Indoor Unit; Outdoor Unit; Remote Controller; Preparation Before Operation - Mitsubishi Electric MSZ-FD50VA Manual De Instrucciones

● OPERATING INSTRUCTIONS ●
N
AME OF EACH PART

Indoor unit

Display section
Operation
indicator
lamp
Front panel
Air fi lter
Air inlet
Plasma
deodorizing
fi lter
Plasma elec-
trode unit
Page 7
Plasma
anti-allergy
i-see sensor
enzyme fi lter
Air outlet
Fan guard
Fan
Horizontal vane
Vertical vane

Outdoor unit

Outdoor units may be different in appearance.
P
REPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or turn the breaker on.
Installing the remote controller batteries
Be sure to set the installation position before installing the batteries.
4.
Press RESET
1.
Remove the front lid
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries. The remote controller could malfunction.
• Do not use rechargeable batteries.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.
En-3
Remote control
receiving section
Page 4
Heat
Emergency
exchanger
operation
switch
Page 5
Air inlet (back and side)
Piping
Drainage hose
Air outlet
Drain outlet
Page 4
2.
Insert AAA
alkaline batteries
3.
Install the front lid

Remote controller

Operation display
section
ON/OFF
(operate/stop)
button
Operation select
button
Page 5
FAN speed
control button
Page 6
ECONO COOL
button
Page 7
PLASMA button
Page 7
VANE
control button
Page 6
CLEAN button
Page 7
Lid
Slide down
to open
Only use the remote controller provided with the unit.
Do not use other remote controllers.
Setting current time
1.
Press CLOCK
3.
Press CLOCK again
• Press CLOCK gently using a thin instru-
ment.
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard
from the indoor unit when
the signal is received.
Temperature buttons
Page 5
Off-timer button
Page 7
On-timer button
Page 7
WIDE VANE
button
Page 6
TIME set buttons
Pages 3, 7
Increase time
Decrease time
AREA button
Page 4
CLOCK button
Page 3
RESET button
Page 3
i-see button
Page 4
Remote controller
holder
• Install the remote control-
ler holder in a place where
the signal can be received
by the indoor unit.
2.
Press the TIME buttons to set the
time.
Each press increases/decreases
the time by 1 minute (10 minutes
when pressed longer)