Removing And Installing Metal Cutting Attachment; Mounting Metal Cutting Attachment; Removing The Metal Cutting Attachment; Adjusting Trimmer For User - Stihl FSA 90 Manual De Instrucciones

English
7.5 Removing and Installing Metal Cutting
Attachment
7.5.1

Mounting Metal Cutting Attachment

► Switch off the trimmer, push retaining latch to position
and remove the battery.
1
2
3
4
5
6
7
► Fit the fanwheel (5) on the shaft (6) with fan blades facing
up.
► Place the cutting attachment (4) on the fanwheel (5). If
you are fitting a circular saw blade or a grass cutting blade
with more than 4 cutting edges: Its cutting edges must
face in the same direction as the arrow on the deflector.
► Place the thrust washer (3) on the metal cutting
attachment (4) so that its raised side faces up.
► Place the rider plate (2) on the thrust washer (3) so that its
closed side faces up.
► Insert the stop pin (7) in the bore as far as stop and hold
it depressed.
54
► Rotate the metal cutting attachment (4) clockwise until the
stop pin (7) engages in position.
The shaft (6) is now blocked.
► Fit the nut (1) counterclockwise and tighten it down firmly.
► Remove the stop pin (7).
7.5.2

Removing the Metal Cutting Attachment

► Switch off the trimmer, push retaining latch to position
and remove the battery.
► Insert the stop pin in the bore as far as stop and hold it
depressed.
► Rotate the metal cutting attachment clockwise until the
stop pin engages in position.
The shaft is now blocked.
► Unscrew the mounting nut clockwise.
► Remove the rider plate, thrust washer, metal cutting
attachment and fanwheel.
► Remove stop pin.

8 Adjusting Trimmer for User

8.1

Fitting and Adjusting the Carrying System

1
2
► Put on the shoulder strap (1) or full harness (3).
► Adjust the shoulder strap (1) or full harness (3) so that the
carabiner (2) is about a hand's width below your right hip.
8 Adjusting Trimmer for User
3
2
0458-709-9821-B