Dometic Waeco MagicWatch MWE900 Instrucciones De Montaje página 36

_MWE-900.book Seite 36 Freitag, 12. Januar 2007 4:53 16
Safety and installation instructions
If you disconnect the negative terminal of the battery, the entire data stored
in the volatile memories will be lost.
The following data must be reset, depending on the vehicle equipment op-
tions:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the corresponding
operating manual.
Observe the following installation instructions:
Secure the parts of the parking aid installed in the vehicle in such a way
that they cannot become loose under any circumstances (sudden brak-
ing, accidents) and cause injuries to the occupants of the vehicle.
To prevent damage when drilling, make sure there is sufficient space on
the other side for the drill head to come out (fig. 2, page 4).
Observe the following instructions when working with electrical parts:
When testing the voltage in electrical cables, only use a diode test lamp
(fig. 1 5, page 3) or a voltmeter (fig. 1 6, page 3).
Test lamps with an illuminant (fig. 1 9, page 3) consume voltages that
are too high and can damage the vehicle's electronic system.
When making electrical connections, ensure that:
– They are not kinked or twisted
– They do not rub on edges
– They are not laid through sharp-edged ducts without protection
(fig. 3, page 4).
Insulate all connections.
Protect the cables from mechanical wear (for example rubbing against ex-
isting cables) using cable binders or insulating tape.
Please observe the following instructions in particular:
Observe the applicable legal regulations.
The sensors may not cover signal lamps.
36
MagicWatch MWE900