Dometic Waeco SinePower MSI2312T Instrucciones De Montaje página 46

Connecting the inverter
!
WARNING! Danger of electrocution!
If you wish to connect more than one appliance to the inverter and
install a socket distribution circuit, you must arrange a circuit
breaker (residual current circuit breaker) and set a grounding
bridge in the inverter.
➤ Install a residual current circuit breaker in the socket distribution circuit.
9.6 Setting the earthing bridge (fig. 5 5, page 4)
➤ Remove the earthing screw from the bottom hole.
➤ Screw the screw into the top hole.
9.7 Connecting the MCR-7 or MCR-9 remote control
(accessory)
A
NOTICE!
 Only plug in the connection to the remote control in the remote
port. The device can be damaged by connecting it incorrectly.
 Ensure that the remote control and inverter are supplied with
the same input voltage.
 Follow the instruction manual of the remote control.
➤ Connect the remote control (accessory) to the remote port (fig. 5 12,
page 4).
9.8 Connect external switch to turn device on and off
I
NOTE
Use cables with a cable cross section of 0.25 – 0.75 mm².
You can use the following as an external switch:
 external switch, voltage supply from the inverter: fig. 8, page 6
 Control unit with relay or transistor circuit (TR): fig. 9, page 6
 external switch with voltage supply from the battery (BAT) of the vehicle:
fig. 0, page 6
 external switch with its own voltage supply (DC POWER) e.g. from the ig-
nition: fig. a, page 6
46
SinePower
EN