How To Wire This Unit - Clarion DVH940 Manual De Instrucciones

How to Wire This Unit

Perform the settings and
connections in the order
indicated by the drawing
below.
1
CeNET Cable
• To connect a CeNET cable, hold it with the
connector facing as shown, and insert
securely.
• When disconnecting a CeNET cable, grasp
the slide cap and squeeze gently.
2
Optical Digital Cable
• Insert the black connector securely into the
digital signal input connector until it locks.
The cable clip can be used to secure up to
two optical digital cables.
• When disconnecting a optical digital cable,
squeeze the tabs at the right and left sides
of the connector, and pull gently.
Note:
• The optical digital cable should not be bent
with a gentle arc radius of 1.5 cm or less. If
it is bent sharper than this, the performance
of the cable will be greatly reduced and the
cable may be damaged.
3
RCA Pin Cable
• When connecting an RCA pin cable, be
sure to confirm the source of the
connection first.
4
[RESET] switch
• Following completion of wiring, press the
[RESET] switch to return to default
settings.
12
DVH940
Throughout the process of wiring this
unit, disconnect the negative (–) terminal
of your automobile's battery, and leave it
disconnected until completely finished.
Handling wires while the terminal is
connected could result in dangero
electrical shock or injury if an scccidental
short circuit shoud occur.
Sliding cap
Note:
• Route the CeNET cable with plenty of extra room
so that the connector will not become
disconnected accidentally.
Optical Digital cable
(black connection)
Squeeze right/
Note:
• Always turn the main [POWER] switch [OFF]
before connecting or disconnecting digital fiber-
optic cables.
CAUTION
CeNET connector
Cable clip
left tabs
CeNET cable