Wiring Techniques; Name Of Parts - Clarion DVH940 Manual De Instrucciones

6. WIRING TECHNIQUES

Name of Parts

[STAND-ALONE/SLAVE] switch
* The factory default setting is
SLAVE position.
SLAVE
1 CeNET connectors
Connect to center unit using CeNET cable.
2 Front RCA output connectors
Connect to external power amplifier using
RCA pin cable.
3 Rear RCA output connectors
Connect to external power amplifier using
RCA pin cable.
4 Sub-woofer RCA output connectors
Connect to external power amplifier using
RCA pin cable.
5 Center speaker RCA output connectors
Connect to external power amplifier using
RCA pin cable.
6 Digital input connector
Connect to DVD/CD changer using optical
digital cable (sold separately or included).
* Connect to black connector side
7 Cable clip hole
Insert cable clip to hold optical digital cable in
place.
8 RESET switch
Press to reset circuitry if no sound is
produced.
Note:
• Be sure the CeNET cable is connected when
pressing the [RESET] switch.
STAND
ALONE
Use When Connecting Optional
Control Unit (DVC920)
9 [STAND-ALONE / SLAVE] switch
0 Analog input connectors (RCA)
! Control unit 8P mini DIN plug
@ Control unit power connector
• Set to STAND ALONE when connecting
a control unit.
• Leave at SLAVE position when no
control unit is connected.
Connect to center unit's RCA 2ch output.
Note:
• The following are enabled only when a
control unit is connected.
Connect to control unit.
Connect control unit's power cable here.
* Leave tape in place when not in use.
11
DVH940