Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Figure 2-7. Memory Card Option
Network Option
The Galaxy Automated Test System supports two different network
options:
•
Wired (10 base-T) or
•
Wireless (802.11b).
These options allow for remote data access and/or use of a local receipt
printer.
•
Check that the four white tubing plugs are in place in the ports on
the right-hand side of the Test Stand before connecting the
Network Interface module.
•
Only install (or remove) the Network Interface with the power cord
removed from the "MASTER" or rightmost Test Stand.
•
If the Network Interface will be installed on an existing network,
please contact a Network Administrator to perform the rest of the
setup.
•
Each Network Interface is shipped from MSA with the following
factory defaults (these factory defaults can also be recovered by
using the Network Reset command from the Test Stand):
•
Wired Interface (radio will be turned OFF on wireless units)
•
IP: 192.168.0.100
•
To alter these settings, connection must first be made to the
Network Interface. This can be done using any web browser with
2-9
Capítulos
Tabla de contenido
