Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Leak test
!
Warning!
•
This test must be carried out in a well-ventilated area before using the griddle, every
year, after a long period of disuse, or when replacing the gas cylinder.
•
Do not check for gas leaks near an open flame. If you smell gas, immediately turn off
the gas supply.
Soap
1.
Make sure that all of the control knobs are in the closed position "
2.
Prepare a soap and water solution (1/2 water and 1/2 soap) and run the solution through the gas
connection points of the cylinder, regulator, hose and gas connection using a brush.
3.
Open the gas cylinder valve.
4.
The formation of bubbles above some of the seals indicates a gas leak. Turn off the gas supply,
tighten all of the seals and repeat the test.
5.
If a part is defective, have it replaced. The appliance must not be put into service until the leak has
been resolved. If the problem persists, contact your retailer or a specialised gas technician.
Changing the gas cylinder
•
Always change the gas cylinder away from any possible source of fire.
•
Do not change the gas cylinder when using the appliance. The control knobs must be in the closed
•
position "
" (stop).
•
Wait for the appliance to cool down completely.
•
The change must only be made outdoors.
•
Do not smoke when changing the gas cylinder.
•
Do not change the cylinder if the outside temperature is above 45°C, or if the cylinder has been
stored at similar temperatures.
•
When the cylinder is empty, have it filled or replaced by an authorised dealer, where your cylinder will
not be filled to more than 80% of its capacity to allow the gas to expand the temperature.
50
V.1.0
gas cylinder connection
•
" (stop).
use
!
Warning!
•
Before you start using your griddle, make sure that all of the control knobs are in the
•
"
OFF" (stop) position.
•
Check that the cylinder/regulator/hose/appliance assembly is not leaking.
•
Make sure that the burners (venturi tube) and/or injectors are not obstructed (e.g.
cobwebs).
•
Check that the supply hose is not damaged or expired, and that it does not come into
contact with sharp or hot parts of the appliance.
Preparation before cooking
•
Before using the griddle for the first time, wipe the cooking griddle with a solution of water and
washing-up liquid and a soft sponge. Rinse and dry thoroughly.
•
To prevent food from sticking to the plate, coat it with cooking oil before each use.
Description of a control knob
The following symbols are located on the control panel around each knob:
OFF
OFF
OFF
Knob marker pointing to "OFF": Valve closed: no gas supply
Large flame: maximum flow rate
Small flame: reduced flow rate
To control the flame power, turn the knob anticlockwise.
Switching on the griddle
The piezo electric ignition system is integrated into the control knobs.
IMPORTANT: For models with a hood, light the griddle with the HOOD OPEN. Never switch on
the appliance with the hood closed.
1.
Make sure that all of the control knobs are in the "
2.
Open the gas supply on the gas cylinder or regulator.
OFF
•
OFF" (stop) position.
V.1.0
51
use
Capítulos
Tabla de contenido
Solución de problemas
