Tabla de contenido
Operating panel
GB
A Display
B Feed button
C Online button
D Cut button
E Prog button
The 64-xx has three different operating
modes: offline, online and report mode. The
display [A] shows the active operation mode.
After powering-on, the printer is in online
mode.
Display messages are quoted here in the
national language, if it is provided by the prin-
ter (otherwise in english). Refer to chapter 5
to learn how to change the language setting.
Online
The printer is ready to receive data. Print jobs
sent to the printer will be printed immediately.
One of the following display messages may
appear:
ONLINE 0 JOBS
ONLINE 0. JOBS
generated (--> point beside the 0).
ONLINE 3 JOBS
Restcount
labels to print.
ONLINE 3 JOBS
Stopped
print. Continue by pressing Feed.
Print contrast
75%
pressing Prog).
Press Online to switch between online and
offline mode!
Offline
The following pictograms show the buttons,
which have to be pressed (left side) and the
display after pressing those buttons (right
side). The pressed buttons are marked black.
OFFLINE 0 JOBS
Slow feeding of label material and ribbon:
Online
Feed
A
D
C
B
The printer is waiting for
print jobs.
A print job is being sent;
the print image is being
3 jobs are loaded, the first
of which is just being pro-
25
ceeded. There are still 25
A print job has been stop-
ped (by pressing Online).
25
There are still 25 labels to
Energy supply of the print
head: 75% of the maxi-
mum level (activated by
The printer is initially swit-
ched offline
OFFLINE 0 JOBS
feeding...
Feeding of label material:
Slow feeding of material backwards:
Cut
Online
Cut (if a cutter is mounted):
E
Cut
Access to the parameter menu:
Restarting the printer:
Cut
Online
¤
User manual 64-xx, topic section „Commis-
sioning and Operation", chapter „Operation in
CD
offline mode".
Report mode
Status no.:
No gap found
Acknowledge status messages by pressing
Online!
The most important status messages:
(M: = measure)
5001: No punch detected. M: Check the ma-
terial settings; Clean the punch sensor;
Check the position of the punch sensor.
5002: Material end. M: Insert new ribbon;
Check the position of the material guiding.
5005: Cutter fault (if mounted). M: Check the
cutter sensor; Clean the cutter blades.
5008: Ribbon end. M: Insert a new ribbon roll.
5060: Stacker (if attached) full or Stacker-
covering open. M: Empty stacker, close
covering.
¤
User manual 64-xx, topic section „Status
reports".
CD
OFFLINE 0 JOBS
Feed
feeding...
OFFLINE 0 JOBS
feeding...
OFFLINE 0 JOBS
cutting...
PRINT INFO
Prog
System start...
Feed
Status messages consist
5001
of a status number and a
short description.
57
Tabla de contenido
