Cleaning The Unit - EGO POWER+ BC1500E-F Manual Del Usuario

3. Rotate the spool retainer in the arrow direction,
as necessary, to align the LOAD line on the spool
retainer with the eyelets in the spool base (Fig. O).
Fig. O parts description see below:
O-1 Eyelet
O-2 LOAD Line
O-3 Arrow Direction
4. Cut 5m long cutting line, about 5 times the length of
the trimmer aluminium shaft. Insert the line into the
mounting hole inside the eyelet (Fig. P). Push and pull
the line from the other side until equal amounts of
line appear on both sides of the spool.
5. Press, while rotating the spool retainer in the arrow
direction, to wind the line onto the spool until
approximately 14cm of line is showing on each side
(Fig. Q).
6. Push the spool retainer down while pulling on the
lines to manually advance the line and to check for
proper assembly of the trimmer head.
When the cutting line breaks from the line outlet or the
cutting line is not released when the trimmer head is
tapped, follow the steps below:
1. Press the two release tabs on the spool retainer and
remove the spool retainer by pulling it straight out
(Fig. R).
Fig. R parts description see below:
R-1 Release Tab
R-2 Spool Retainer
R-3 Spool Base
2. Remove the cutting line from the spool retainer.
3. With one hand holding the spool base, use the other
hand to grasp the spool retainer and align the tabs
on the spool retainer with the holes in the spool base
(Fig. S); Use your palm to press and rotate the spool
retainer left and right until the tabs lock with the
spool base (Fig. T).
4. Following the instructions in " LINE REPLACEMENT "
to reload the cutting line.
56 VOLT LITHIUM-ION BRUSHLESS BIKE HANDLE LINE TRIMMER — BC1500E-F
MAINTENANCE
WARNING:
When servicing, use only identical
replacement parts. Inspect and maintain the machine
regularly. To ensure safety and reliability, all repairs
should be performed by a qualified service technician.
WARNING:
Battery tools do not have to be plugged
into an electrical outlet; therefore, they are always in
operating condition. To prevent serious personal injury,
take extra precautions and care when performing
maintenance, service or for changing the cutting
attachment or other attachments.
WARNING:
To prevent serious personal injury,
remove the battery pack from the tool before servicing,
cleaning, changing add-on attachments or removing
material from the unit.

CLEANING THE UNIT

◾
Clean the unit using a damp cloth with a mild detergent.
◾
Do not use any strong detergents on the plastic
housing or the handle. They can be damaged by certain
aromatic oils, such as pine and lemon, and by solvents
such as kerosene. Moisture can also cause a shock
hazard. Wipe off any moisture with a soft dry cloth.
◾
Use a small brush or the air discharge of a small
vacuum cleaner brush to clean the air vents on the
rear housing.
STORING THE UNIT
◾
Remove the battery pack from the line trimmer when
it is not in use.
◾
Clean the tool thoroughly before storing it.
◾
Store the unit in a dry, well-ventilated area, locked-up
or up high, out of the reach of children. Do not store
the unit on or adjacent to fertilizers, petrol, or other
chemicals.
EN
11