Mounting The Camera; Tools Required - Waeco PerfectView CAM80 Instrucciones De Montaje

PerfectView CAM80
8

Mounting the camera

8.1

Tools required

For installation and assembly you will require the following tools:
 Drill bit set (fig. 1 1, page 3)
 Drill (fig. 1 2, page 3)
 Screwdriver (fig. 1 3, page 3)
 Set of ring or open-ended spanners (fig. 1 4, page 3)
 Measuring ruler (fig. 1 5, page 3)
 Hammer (fig. 1 6, page 3)
 Centre punch (fig. 1 7, page 3)
To make and test the electrical connection, the following tools are required:
 Diode test lamp (fig. 1 8, page 3) or voltmeter (fig. 1 9, page 3)
 Crimping tool (fig. 1 10, page 3)
 Insulating tape (fig. 1 11, page 3)
 Cable bushing sleeves, if necessary
To fasten the cables you may require additional cable binders.
8.2 Mounting the camera
!
CAUTION!
Select a location for the camera and attach it so securely that it cannot under
any circumstances fall off and injure bystanders (e.g. by being knocked off by
branches brushing over the roof of the vehicle).
I
NOTE
If installing the camera alters the vehicle height or length specified in the vehi-
cle documents, your vehicle must be inspected by the appropriate authorities.
Make sure that you are in possession of documents verifying that your vehicle
has passed this inspection.
EN
Mounting the camera
27