6 von 15
en
Fitting instructions - Fluff filter box FFK8005
Included parts
No.
Mat. no.
Designation
1
Filter box guide
1
Drawer
1
Filter
1
Connection box
2
Raised-head screw M6 x 12
4
Nut M6
1
Key
2
Pipe bend 70 x 87
1
Pipe bend 50 x 87
1
Cap
1
Hose clip
Danger due to incorrectly carried out service and repair work
There is a risk of serious damage, injury and even death if service and repair work is carried out incorrectly.
– Service and repair work should only be carried out by a suitably qualified electrician with specialist training,
knowledge and experience.
– All appropriate safety regulations must be taken into account.
– First read the Technical Service Documentation (TSD), then commence work.
Risk of injury due to sharp edges!
CAUTION
There may be a risk of injury due to sharp edges.
Risk of injury due to sharp edges!
A
Protective gloves should be worn and the edge protection, Mat. no. 05057680, should be used.
Fluff filter box FFK8005 fitting
The arrow embossed on the top of the plinth points to the front.
A
Assemble the connection box (1) and fluff filter box guide (2) with 2 M6 raised-head screws (3), 4 washers (4) and 4
M6 nuts (5), see Fig. 1.
The cutout (1) on one of the short sides of the fluff filter box guide is at the front, see Fig. 2.
A
Fit the filter in the drawer. For this, the front of the filter must rest on the protrusions (1) in the drawer, see Fig. 3.
A
Slide the drawer into the fluff filter box guide.
A
Connect the machine to the fluff filter box with two 70 x 87 pipe bends, see Fig. 4.
A
Connect the fluff filter box to the drain with a 50 x 87 pipe bend, see Fig. 4.
A
Close the second drain opening in the fluff filter box with the cap and hose clip.
en
cs
21.12.2017
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 10504700
