Getting To Know Your Appliance; The Control Panel; The Hotplates; Residual Heat Indicator - Siemens ET 75M 11E Serie Instrucciones De Uso

Getting to know your appliance

The instruction manual is the same for various different hobs.
An overview of the models with their dimensions is given on
page 2.

The control panel

Displays
Heat settings
‚ - Š
Residual heat
/
• œ
Timer
‰‰
Controls
Main switch
#
Dual-circuit cooking zone
ð
0IIIIIIIIIIIII+ Settings range
Timer
0

The hotplates

Hotplate
Single-circuit hotplate
$
Dual-circuit hotplate
ð
When the hotplate is activated: the corresponding indicator lights up.
When the hotplate is switched on: the size which was last set is automatically selected again

Residual heat indicator

The hob has a two-stage residual heat indicator for each
hotplate.
If appears in the display the hob is still hot. It may be used,
•
for example, to keep a small meal warm or to melt cooking

Setting the hob

This section informs you how to set the hotplates. The table
shows heat settings and cooking times for various meals.

Switching the hob on and off

The main switch is used to switch the hob on and off.
To switch on: touch the symbol. A signal sounds. The
#
indicator above the main switch lights up. The hob is ready for
use.
To switch off: touch the symbol until the display above the
#
main switch goes out. All hotplates are switched off. The
residual heat indicator remains on until the hotplates have
cooled down sufficiently.
12
Notes
■
■
■
Activating and deactivating
Select the hotplate and touch the
chocolate. As the hotplate cools down further, the display
changes to
cooled sufficiently.
Note: The hob switches off automatically if all hotplates have
been switched off for more than 20 seconds.

Setting a hotplate

Set the desired heat setting on the control panel.
Heat setting 1 = lowest setting
Heat setting 9 = highest setting
Every heat setting has an intermediate setting. This is identified
by a dot.
When you touch a symbol, the respective function is
activated.
Always keep the controls dry. Moisture reduces their
effectiveness.
Do not pull pans close to the displays and sensors. The
electronics could overheat.
symbol
ð
. The display remains lit until the hotplate has
œ