Schneider Schirme Rhodos Twist Bianco Instrucciones De Montaje Y De Uso página 42

Assembly
Place the two elements of the cross base (A + B) one on top of the other as
shown and screw them firmly to the rotating plate (D).
Use the screws M8x20 (F) and one washer (G) for each screw.
Bolt the tube (C) to the rotating plate (D).
Use the screws M8x14 (E) and one washer (G) for each screw.
NOTE:
The tube is at an angle of approx. 3°
from the perpendicular away from the
parasol.
This is intentional and thus not a
ground for complaint.
The slanted design of the tube
prevents the pole from hanging
forward when the parasol is open and
also gives the parasol set an overall
elegant appearance.
Place the assembled cross base at the location where the parasol is to be
set up. Make sure the ground under the base is firm and level.
Insert 4 paving slabs in the cross base.
IMPORTANT:
Always insert 4 paving slabs of size 50 x 50 x 5 cm! The
total weight of the paving slabs must be minimum 100 kg.
Never use the parasol stand without paving slabs.
E
F
G
42
L
G C
D
A
B