Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1 door handle
2 door handle mountings
–
Remove any exterior and interior packaging materials completely.
–
Caution:
Keep any packaging materials well away from children, as they are a potential source
of danger e.g. from suffocation.
–
Fit the upper (10) and lower door mountings (13) to the door handle/bar (12).Use the screws (9)
to mount the handle on the door. Ensure that the handle is properly and securely attached. Place
the screw covers (11) over the screw heads.
●
Before it is connected to the mains, the unit must be thoroughly checked for transport damage,
including its power cord.
–
Clean the unit according to the instructions given in the
Installation
The appliance should be set up in a well-ventilated, dry room. It should be operated in an ambient
temperature of 10 to 38 °C and a relative humidity of max. 70 %. Do not expose the appliance to
direct sunlight, and do not position it next to any heat sources (radiators, cookers etc).
To ensure sufficient air circulation, maintain a minimum distance of 50 mm between the rear of the
unit and the wall. The top clearance must be at least 150 mm.
The unit must not be installed inside a cabinet, nor directly below a hanging cupboard, shelf or
similar object.
Ensure that the door can swing open to an angle of 120°.
If the floor is uneven, the adjustable feet on the unit can be used to compensate and ensure optimum
stability. The whole unit should be installed at a slight angle in such a way that it leans to the rear:
this will ensure that the door closes automatically. However, both front feet must be set to the same
height.
Ventilation
The heated air around the rear of the unit must be able to circulate freely. Therefore, ensure that the
air circulation behind the unit is not obstructed.
Reversible door
The design provides for the door to be reversed, i.e. for right-hinged (default installation) to become
left-hinged.
Caution: Reversing the door requires changes to the electrical system. Do not attempt to reverse the
door without contacting the customer service.
Control panel and interior light
●
Before the unit is connected to the mains power after installation, it should be left standing in
position for about 2 hours.
●
The unit has two temperature zones.
De-frosting and cleaning section.
12
Tabla de contenido
