Stihl HTE 60 Manual De Instrucciones página 42

English
The shaft should always be held at an
angle of 60° or less.
The least tiring working position is a tool
angle of 60°.
Any lesser angle may be used to suit the
situation.
Cross-cut
To avoid pinching the bar in the cut,
position the housing against the branch
and then perform the cross-cut from the
top downwards.
40
Relieving cut
2
1
To avoid tearing the bark on thick
branches, always start by performing a
relieving cut (1) on the underside of the
branch.
To do this, apply the cutting
N
attachment and pull it across the
bottom of the branch in an arc as far
as the bar nose.
Position the housing against the
N
branch and then perform the cross-
cut (2).
Flush-cutting thick branches
A
4
If branch diameter is more than 10
N
cm, first perform undercut (3) and
then cross-cut at a distance of about
20 cm (A) from the final cut. Then
carry out the flush-cut (4), starting
with a relieving cut and finishing with
a cross-cut.
3
HTE 60