V2 ZARISS Serie Manual Del Usuario página 53

GO
Ch1
AP1
AP2
1
?
2
Ch2
SinG
doP
Ft.no
Ft.S i
3
?
4
t.LAu
ESC
SUP
inF
Er93
Er94
Er91
Select this parameter depending on the position (superior or inferior)
of the gate leaf in motion
SUP
the gate leaf in motion is the leaf that should open first
inF
the gate leaf in motion is the leaf that should open second
PLEASE NOTE: if installation envisages one motor only, select SUP
Select this parameter depending on the direction of opening of gate
leaf 1
AP1
the gate leaf is opening
Ch1
the gate leaf is closing
Having selected this parameter, the control unit moves the
SLAVE motor
1
If the control unit detects the SLAVE motor, the display shows
Select this parameter depending on the direction of opening of gate
leaf 2
AP2
the gate leaf is opening
Ch2
the gate leaf is closing
Having selected the parameter, press OK to move to the next phase.
Er93
If the display shows , this means the SLAVE motor is connected
incorrectly.
Check the SLAVE motor connection and repeat the initialisation
procedure
2
If the control unit does NOT detect the SLAVE motor,
SinG
the display shows
If the installation envisages only one motor, press OK to move to the
next phase.
If the installation envisages two motors, select the
and press OK.
Er94
The display will show
connected, or is connected incorrectly.
Check the SLAVE motor connection and repeat the initialisation
procedure
3
If the control unit does not detect a photocell on the PHOTO input,
Ft.no
the display shows
If the installation does not envisage the use of a photocell, select
Ft.no
and press OK to move to the next phase.
The photocell will be automatically disabled.
If installation envisages the use of a photocell, select
Er91
OK. The display will show
connected, or is connected incorrectly.
Check the photocell connection and repeat the procedure.
4
If the control unit detects a photocell connected correctly to the
PHOTO input, it automatically switches to the working time
self-training phase.
Press OK to start the self-training phase.
ESC
Select and press OK to exit the menu without performing the
time self-training phase.
Please note: in the case of exiting without self-training, it will
not be possible to operate the gate.
In any case, it will be possible to perform self-training in a separate
phase and program the remainder of the control unit functions, using
the specific menu.
- 51 -
doP
menu option
to indicate that the SLAVE motor is not
Ft.Si
to indicate that the photocell is not
AP2
and press