Transporting By Trailer; Machine Storage; First Period Of Use - Nilfisk RS 850 Instrucciones De Uso

TRANSPORTING BY TRAILER

To transport the machine with a trailer, use the hooks and anchors shown below.
WARNING!
Machine anchor/lifting must be performed by qualifi ed personnel.
Available hooks
1. The machine is equipped with the following hooks:
• No. 2 lifting hooks (1, Fig. B), to be used only when the hopper is empty.
• No.1 front towing/anchor hook (2, Fig. B).
• No.1 rear towing/anchor hook (3, Fig. B).
Anchorage
2. To anchor the machine in case of transport by trailer, proceed as follows:
• Set the machine to transport mode (see the procedure in the relevant paragraph).
• Remove the ignition key (24, Fig. D).
• Engage the parking brake (13, Fig. E).
• Close all lids, panels, etc.
• Anchor the machine with the front and rear towing hooks (2 and 3, Fig. B).
• Anchor the machine with two suitable bands (4 and 5, Fig. B), placed over the rear axle support (6), and on the front left
and right cab footboards (7) respectively.
Temporary lifting
3. To lift the machine temporarily, proceed as shown below:
• Set the machine to transport mode (see the procedure in the relevant paragraph).
• Check that the hopper is empty.
WARNING!
If it is necessary to lift the machine in case of emergency and the hopper is not empty, pay special attention,
because the waste weight can cause the machine unbalance, moreover the hooks are subject to a greater
stress.
• Remove the ignition key (24, Fig. D).
• Engage the parking brake (13, Fig. E).
• Close all lids, panels, etc.
• Anchor the machine to the lifting hooks (1, Fig. B) with suitable ropes.
• Lift the machine carefully, as shortly as possible, with a suitable hoisting system and according to the accident-prevention
rules.

MACHINE STORAGE

If the machine is not going to be used for more than 30 days, proceed as follows:
1. Empty the dust control system water tanks according to the following procedure.
2. Prepare the machine, as shown in the After Machine Use paragraph.
3. Store the machine indoor, in a clean and dry place, protected from bad weather conditions and with the following values:
• Temperature: +33.8°F to +122°F (+1°C to +50°C)
• Humidity: maximum 95%
4. Disconnect the negative connector from the battery (34, Fig. F).
5. Handle the diesel engine as shown in the relevant Manual.

FIRST PERIOD OF USE

After the fi rst period of use (fi rst 8 hours) it is necessary to perform the following procedures:
1. Check the fastening and connecting elements for proper tightening. Check the visible parts for integrity and leaks.
2. After the fi rst 50 working hours, perform checks and replacements shown in the Scheduled Maintenance Table.
INSTRUCTIONS FOR USE
RS 850 33015123(3)2008-02
ENGLISH
27