Maintenance; General Maintenance Instructions - Stihl RT 4082 Manual De Instrucciones

Fit V-belt (2) onto V-belt pulley (6).
When fitting, ensure that the V-belt is
installed correctly (not twisted).
● Slowly release V-belt tensioner lever (5)
and ensure that the V-belt is routed
correctly in the V-belt pulley.
● Install the discharge chute. (
● Install the grass catcher box. (
Risk of injury:
After attaching the mowing deck,
perform an operational check.
Ensure that no other persons,
particularly children or animals are
in the vicinity. Only perform the
operational check when the user is
sitting on the machine.
Installing the rear V-belt cover
Danger of burns:
Allow the machine, particularly the
exhaust system to cool down
completely before installing the rear
V-belt cover.
● Select the lowest cutting level.
92
14.6)
12.10)
Insert the rear V-belt cover (1) with the
retaining device at the locating lug (2) on
the gearbox (3) in direction of arrow.
Push rear V-belt cover (1) upwards and
hold. Turn the closure screw (2) clockwise
through 90°.
Note
After installing, check that the rear
V-belt cover is seated securely.
Avoid damage to the machine.
After installation, the V-belt must be
free and must not contact the rear
V-belt cover.
Check this visually.

14. Maintenance

Risk of injury!
Before all maintenance and repair
work, carefully read and observe
the section "For your safety" and
especially the subsection
"Maintenance and repairs". (
Remove the ignition key
to prevent inadvertent
starting of the engine.
Always wear gloves.
Never touch the mowing
blades before they have
come to a standstill.
For safety reasons, maintenance
operations on the brakes are not
permitted. Only allow adjustment
and maintenance operations to be
performed by a specialist dealer.
STIHL recommends
STIHL specialist dealers.

General maintenance instructions:

● The maintenance schedule and
maintenance intervals must be strictly
observed.
● Observe the maintenance schedule
and maintenance operations in the
engine instruction manual.
0478 193 9904 A - EN
4.)