Level Sensor (Grass Catcher Box); Self-Diagnosis When Starting - Stihl RT 4082 Manual De Instrucciones

Disengaging the gearbox
Pull the gearbox freewheel lever (1)
outwards to the stop.
Engaging the gearbox
Lift up the gearbox freewheel lever (1) and
then press it inwards to the stop.

8.15 Level sensor (grass catcher box)

A continuous tone sounds if the grass
catcher box is full. This signals that the
grass catcher box needs to be emptied.
80
Disengaging the mowing deck
stops the continuous tone.
The time for the filled grass catcher box
signal is adjusted by modifying the length
of the (grass catcher box) level sensor.
This allows you to adapt filling of the grass
catcher box to the characteristics of the
clippings.
A shorter sensor generally causes later
triggering of the signal (the grass catcher
box is filled to a greater extent, ideal for
very dry clippings).
The level sensor can be adjusted to 6
notched positions.
In delivery condition, the level sensor
(grass catcher box) is fully extended.
Adjusting the level sensor:
● Stop the engine. ( 12.3)
● Engage the parking brake. (
● Remove the grass catcher box.
( 12.10)
Extend or shorten the level sensor by
moving slide (1) of the (grass catcher box)
level sensor in the direction of the arrows.
● Attach the grass catcher box. (
9. Electronics
In order to ensure safe operation, the ride-
on mower is equipped with electronics
which check all the safety devices before
each starting procedure and when the
mower is running.

9.1 Self-diagnosis when starting

Before the engine is started, the
electronics perform self-diagnosis. This
checks switches, wiring, etc. for correct
functioning.
Activating self-diagnosis:
● Sit on the driver's seat.
● Release the parking brake. (
8.10)
● Turn the ignition key to the "ignition on"
position (
switches or actuate any pedals.
Self-diagnosis without faults:
A short beep sounds – the electronics are
activated and the ride-on mower is ready
to start.
● Start the engine. (
Self-diagnosis with faults:
A continuous beep or three successive
beeps sound.
A continuous beep signals a fault in the
electronics or a battery connected with the
incorrect polarity.
● Turn the ignition key to the "engine off"
position. (
12.10)
8.10)
8.1) – do not press any
12.2)
8.1)
0478 193 9904 A - EN