Standard Equipment; Preparing The Machine For Operation; Assembling The Handlebar (Rm 4 R, Rm 4 Rt, Rm 4 Rv); Rm 4 Rtp - Stihl RM 4 R Manual De Instrucciones

RM 4 RTP:

Start the engine.
RM 4 R, RM 4 RT,
RM 4 RV:
Stop the engine.
RM 4 RTP:
Stop the engine.
RM 4 RT, RM 4 RV:
Switch on self-propulsion.
RM 4 RTP:
Switch on self-propulsion.
RM 4 RV:
Set the driving speed.
( 11.3)
RM 4 RTP:
Wear hearing protection
when working.
0478 111 9943 A - EN
Service position marking on
the detent segment.
( 12.1)

6. Standard equipment

Item Designation
A Basic unit with handlebar
Instruction manual
Engine instruction manual
RM 4 R, RM 4 RT, RM 4 RV:
B Cable clips
C Flat head bolts
D Quick-clamping devices
E Protective sleeves
RM 4 RTP:
B Cable clips
F Flat head bolts
G Retaining washers
H Lock nuts
I Protective sleeves
7. Preparing the machine for
operation
7.1 General
Risk of injury!
Observe the safety instructions in
the section "For your safety" (
● Place the machine on level and firm
ground when performing all the
operations described.
7.2 Assembling the handlebar
(RM 4 R, RM 4 RT, RM 4 RV)
● Fit protective sleeves (E) onto
upper handlebar (1) with the long side
facing inwards.
2
● Hold upper handlebar (1) on lower
Qty.
handlebar (2) and insert screws (C)
1
through bores (3) from the inside
outwards.
1
1
● Screw in quick-clamping device (D) at
screws (C) (it should project by about
one screw thread turn) and fold
upwards.
2
● Check correct assembly:
2
Quick-clamping devices (D) must be
2
sufficiently tightened so that they are
2
pressed tightly against the handlebar
and the upper handlebar is firmly
connected to the lower handlebar.
If the handlebar is not firmly installed or
2
the quick-clamping devices are not
2
correctly located, fold open the quick
2
clamping devices and adjust them to
the correct position by screwing out and
2
in.
2
7.3 Assembling the handlebar
(RM 4 RTP)
● Fit protective sleeves (I) onto
upper handlebar (1) with the long side
facing inwards.
4.).
3
4
39