Product Specifications; Features; Ground Terminal - Homelite UT905000P Manual Del Operador

PRODUCT SPECIFICATIONS

ENGINE
Engine Type ............................ 4 Stroke, OHC (Chain Drive)
Fuel Volume ................................................................ 6 gal.
GENERATOR
Rated Voltage .....................................................120V/240V
Rated Amps ..................................................... 41.6A/20.8A
Rated Running Watts* ............................................5,000 W
*Rated running watts determined by PGMA Standard G200
KNOW YOUR GENERATOR
See Figure 1.
The safe use of this product requires an understanding of the
information on the product and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
AC CIRCUIT BREAKER
The circuit breaker is provided to protect the generator
against electrical overload. The circuit breaker may be reset
by lifting the circuit breaker reset lever.
AIR FILTER
The air filter helps to limit the amount of dirt and dust drawn
into the unit during operation.
CHOKE LEVER
The choke lever is used when starting the engine.
ENGINE SWITCH
The engine switch is used in combination with the recoil
starter grip to start the generator. It is also used to turn the
generator off.
FUEL TANK
The fuel tank has a capacity of 6 gallons.

FEATURES

Rated Starting Watts ..............................................6,250 W
Rated Frequency ........................................................60 Hz
DIMENSIONS
Length ..................................................................... 26.5 in.
Width .......................................................................... 20 in.
Height ......................................................................... 23 in.
Weight .................................................................... 160 lbs.
FUEL VALVE
Fuel flow from the fuel tank to the engine is turned on and
off using the fuel valve.

GROUND TERMINAL

The ground terminal is used to assist in properly ground-
ing the generator to help protect against electrical shock.
Consult with a local electrician for grounding requirements
in your area.
OIL CAP/DIPSTICK
Remove the oil fill cap to check and add lubricant to the
generator when necessary.
OIL DRAIN PLUG
When changing the engine lubricant, unscrew and remove
the oil drain plug to allow old engine lubricant to be drained.
RECEPTACLES
Your generator has the following single phase, 60 Hz outlets:
four 120 Volt AC, 20 Amp receptacles, and one 240 Volt AC,
20 Amp receptacle. These can be used for operating appro-
priate appliances, electrical lighting, tools, and motor loads.
RECOIL STARTER GRIP
The recoil starter grip is used (along with the engine switch)
to start the generator's engine.
Page 10 — English