Chicco Oasys 23 EVO Instrucciones De Uso página 30

ways in a forward facing direction. Never use
this child car seat on vehicle seats which are
facing sideways or rearwards (diag. 4).
WARNING! According to car accident statis-
tics, the rear seats of a vehicle are generally
safer than the front seat: it is therefore recom-
mended to fit the child car seat into the rear
seats of the car. In particular, the central rear
seat is the safest, when fitted with a 3-point
safety strap: in this case it is recommended to
fit the child car seat onto the central rear seat
of the vehicle.
If the child car seat is fitted in the front seat
of the car, in order to ensure maximum safety,
it is recommended to push the seat back
as much as possible, bearing in mind the
comfort of the passenger sitting in the seat
directly behind it and adjusting the backrest
to the most vertical position. If the vehicle is
fitted with an adjuster to regulate the height
of the safety belt, position it as low as possible.
Check that the safety belt adjuster is behind
(or at the most aligned) with the backrest of
the vehicle seat (Diag. 5A and 5B).
It is not recommended to fit the child car seat
into a front seat equipped with airbag. If you
wish to fit the child car seat in any seat pro-
tected by airbag, always refer to the vehicle
instructions manual.
Make sure that the buckle seat belt is not too
high and not rests on the armrest of the car seat
(Diag 3). Otherwise, try to install the car seat for
your child on another car seat in the car.
INSTRUCTIONS FOR USE
Contents
• F itting the child car seat inside the vehicle us-
ing safety belts and placing the child inside.
• I nstalling the child seat inside the vehicle
without the child inside.
• H ow to remove the child from the child car seat.
• R emoval of the child car seat from the vehicle.
• I nstalling and removing the cup holder.
• A djusting the height of the back rest.
• A djusting the width of the back rest.
• A djusting the inclination of the child car seat
backrest/seat.
• R emovable backrest/seat covers
• C leaning and maintenance of the seat covers
Parts
A. Headrest
B. Diagonal belt guide
C. Backrest
D. Armrests
E. Seat
F. Lap belt guide
G. Cup holder
H. Reclining adjuster button
I. Safety belt guide open/close button
J. Cup holder clip
K. Backrest width adjuster wheel
L. Backrest height adjuster lever
M. Rear pocket for instruction booklet
N. Side wings
Fitting the child car seat inside the vehi-
cle using safety belts and placing the
child inside
WARNING! These instructions and diagrams
are for the installation of the child car seat on
the right back seat.
To fit the child car seat in other positions, carry
out these operations in the same order.
1. P lace the child car seat onto the vehicle seat
with the backrest up against the vehicle
seat backrest (Diag. 6).
WARNING! Check that the vehicle headrest
does not interfere with the child seat headrest:
it must not push it forwards (Diag. 7). If this
happens, remove the headrest from the vehi-
cle seat where you intend to install the child
car seat. Remember to replace the vehicle
headrest when the child car seat is removed
and a passenger uses the seat.
WARNING! The rear side of the child car seat
must be resting against the vehicle seat.
2. P lace your child inside the car seat with his
back correctly placed against the backrest.
3. C heck the backrest height (see paragraph
"ADJUSTING THE HEIGHT OF THE BACKREST")
4. C heck the backrest width (see paragraph
30