Tabla de contenido
Idiomas disponibles
Idiomas disponibles
e the middle hinge. Screw the
hinge onto the opposite side of
the middle hinge. Screw the
t.
hinge onto the opposite side of
.
ure the lower door is aligned
izontally and vertically, so that
ure the lower door is aligned
seals are closed on all sides
zontally and vertically, so that
ore finally tightening the hinge.
seals are closed on all sides
ore finally tightening the hinge.
8.
Position the upper door. Position the hinge of the upper door, fasten it with the screw and
replace the cover plate.
ly set the upper door back into
nserting in onto the middle hinge.
y set the upper door back into
nserting in onto the middle hinge.
he upper hinge and screw it
to the top of the unit.
he upper hinge and screw it
o the top of the unit.
ure the upper door is aligned
izontally and vertically, so that
ure the upper door is aligned
seals are closed on all sides
zontally and vertically, so that
ore finally tightening the hinge.
seals are closed on all sides
ore finally tightening the hinge.
hinge cover back.
9.
With the door closed, check whether the door is aligned horizontally as well as vertically
hinge cover back.
and that the seal closes on all sides before you tighten the upper hinge completely. If
necessary, adjust the adjustable feet.
CLEANING AND MAINTENANCE
Do not use abrasive cleaning agents or solvents.
1.
Disconnect the mains plug from the mains socket.
2.
Take out the food and store in a cool location.
3.
Clean the appliance with a soft cloth, warm water and detergent.
4.
Wipe the door seal with clear water only and then wipe dry thoroughly.
5.
After cleaning reconnect and adjust the temperature control knob as desired.
6.
Put the food back into the appliance.
ndd 9
DEFROSTING
dd 9
The refrigerator defrosts fully automatically.
While the cooling is running, beads of condensation or hoarfrost form at the back of the
refrigerator. This is normal. It is not necessary to wipe off the condensation or frost. The rear
panel defrosts automatically. The condensation runs into the condensation channel and is
conveyed to the cooling from where it evaporates.
Note: Keep the condensation channel and drainage hole clean, so that the condensation can
run out.
www.domo-elektro.be
Middle hinge
Middle hinge
9
9
1/2/16 10:43 am
1/2/16 10:43 am
DO926BFK
47
Tabla de contenido
