Installing The Batteries - Perel CMD01N Manual Del Usuario

Use and store the detector only in normal temperature environments. Temperature extremes can
shorten the life of electronic devices, damage batteries, and distort or melt plastic parts.
WARNING: malfunction may occur if the power is on when the batteries are replaced. Do not
attempt to recharge non-rechargeable batteries, do not puncture or do not throw batteries in fire as
they might explode. Dispose of batteries in accordance with local regulations. Keep batteries away
from children.
4. Treasure Hunter's Code of Ethics
All treasure hunters might be judged by the example you set. Here are a few basic rules you should follow:
 Always get permission before searching any site.
 Respect the rights and property of others.
 Observe all national, state, and local laws while treasure hunting.
 Never destroy historical or archaeological treasures. If you are not sure about an object you have found,
contact a museum or historical society in your area.
 Leave the land and vegetation as it was. Fill in any holes you dig.
 Use your detector only in safe areas.
 Dispose of any junk you find, only in approved areas. Do not leave it for the next treasure hunter to find.
5. Setting up the detector
Refer to the illustrations on page 2 of this manual.
5.1 Assembling the metal detector
 Loosen the knob at the search coil's end and adjust the search coil to the desired angle. (The search coil
should be parallel with the ground). Tighten the knob just enough to keep the search coil from rotating or
wobbling.
 Turn the stem's lock nut clockwise until it loosens [A].
 Lengthen or shorten the stem so when you stand upright with the detector in your hand, the search coil is
level with the ground and about 1/2 to 2 inches (1 to 5cm) above it with your arm relaxed at your side [B].
 Turn the stem's lock nut anticlockwise to lock it in place.
 Loosen the knob at the base of the handle, insert the arm support, and tighten the knob [F].
5.2

Installing the batteries

Caution:
 Use only fresh batteries of the required size and recommended type.
 Do not mix old and new batteries, different types of batteries (standard, alkaline or rechargeable batteries
of different capacities).
1. If the detector is on, turn VOLUME (on the control housing) to OFF (the control clicks) [G].
2. Press the right battery compartment cover's tab and slide the cover off in the direction of the arrow
[F].
3. Place a 9-volt battery into the battery compartment on top of the ribbon, matching the polarity
symbols (+ and -) marked inside.
4. Replace the right battery compartment cover.
5. Press the left battery compartment cover's tab and slide the cover off in the direction of the arrow [I].
6. Place two 9-volt batteries into the battery compartment on top of the ribbons, matching the polarity
symbols (+ and -) marked.
7. Replace the left battery compartment cover.
Caution:
 Always remove old or weak batteries. They can leak chemicals that can destroy electronic parts.
 If you do not plan on using the detector for a week or more, remove the batteries.
 Dispose of old batteries promptly and properly.
You can extend battery life by using earphones, which require less power than the speaker.
5.3 Testing the Batteries
If the detector does not turn on, has weak volume, will not tune properly, has erratic operation or drifts, test
the battery power.
V. 02 – 23/06/2014
CMD01N
4 ©Velleman nv