Switching On And Off - Perel CSOL06 Manual Del Usuario

• All modifications of the device are forbidden for safety reasons.
Damage caused by user modifications to the device is not covered
by the warranty.
• Only use the device for its intended purpose. Using the device in
an unauthorised way will void the warranty.
• Damage caused by disregard of certain guidelines in this manual
is not covered by the warranty and the dealer will not accept
responsibility for any ensuing defects or problems.
• Keep this manual for future reference.
4. Features
• recharges by sunlight via 0.33 W solar panel
• lights up in the dark through the 0.07 W LED
• shines at full strength (0.07 W + 0.5 W LEDs) when the PIR
sensor detects motion within 5 m range
• no wiring, fast and easy installation
• for wall mounting
• on/off switch
• stainless steel housing
• water & corrosion resistant
• IP44
• for outdoor use.
5. Operation
Refer to the illustrations on page 2 of this manual.

5.1 Switching on and Off

• To switch on the device, push the on/off button [1] in the AUTO
position (down). The lamp will automatically light up in standby
mode at night: only the LED behind the horizontal strips [5] is lit.
• When the device detects motion, the bottom LED [6] lights up as
well to illuminate the area.
• To switch off the device, push the on/off button [1] to the OFF
position (up). The battery will charge, but the lamp will not light
up at night.
5.2 The Battery
It is recommended to charge the battery for 1 or 2 days in direct
sunlight before the first use. This will increase battery life
expectancy.
V. 02 – 14/06/2016
CSOL06
4 ©Velleman nv