DeWalt DCV581H Manual De Instrucciones página 13

Using the Appliance (Fig. 2, 4)
1 Attach the appropriate accessory to
the hose (B).
2. Insert D WALT battery pack or plug
E
into a 120V wall outlet.
3. To turn machine on, press the I/O
(on/off) button (C).
Vacuum Cleaning
TO EMPTY TANK (FIG. 5)
The sound of the motor changes and suction is reduced when the
tank is full.
1. Turn machine off. Unplug it from any power source, and remove
the battery pack.
2. Unlatch tank latches (D) and remove power head from the tank.
3. Empty contents of tank into suitable container.
4. Clean or change filter (E). See Filter
section of this manual.
5. Inspect machine for damage by
foreign objects. Contact the nearest
D WALT authorized service center
E
for replacement of damaged or
missing parts.
6. Replace power head onto the tank
and latch securely.
NOTE: The machine must be used in the upright position at all times
to prevent unwanted actuation of the Automatic Vacuum Shutoff. If
FIG. 4
unwanted actuation should happen, turn off the motor and wait until
the motor stops turning. Turn the motor on again and suction will be
restored.
Filter
FILTER CARE (FIG. 6)
The HEPA wet/dry filter (E) included with this vacuum is a long life
filter. To be effective in minimizing dust recirculation the filters MUST
be installed correctly and in good condition.
NOTE: Never operate without a filter in place. A clean filter is the most
important factor in the operation and efficiency of any vacuum. If the
filter becomes clogged beyond cleaning, damaged, or fails to operate
properly, replace only with genuine D
TO CLEAN OR CHANGE THE FILTER (FIG. 5, 6)
1. Turn machine off. Unplug it from any power source, and remove
FIG. 5
2. Unlatch the tank latches (D)
3. Clean the filter by shaking
E
D
11
E
the battery pack.
and remove the power head
from the tank. Twist the filter
(E) to the right to remove it
from the power head.
off excess dust, tapping into
a waste receptacle, then
rinsing under running water.
Depending on the condition of
the filter, a water wash is not
always required. Do not use a
brush to clean filter.
WALT replacement filters.
FIG. 6
E