Connecting The Monitor Electrically - Dometic PERFECTVIEW M71L Instrucciones De Montaje

PerfectView M71L
Fastening the monitor
➤ Set the monitor on the monitor bracket and secure it with the knurled nut (fig. a, page 7).
6.3

Connecting the monitor electrically

The circuit diagram for the LCD monitor can be found in fig. d, page 8.
No.
1
2
3
4
5
6
7
8
9
10
11
12
13
A
NOTICE!
Cables and cable connections that are not properly installed will cause malfunctions or
damage to components.
Correct installation of cables and cable connections ensures lasting and trouble-free
operation of the retrofitted components.
Observe the following instructions when laying the connection cables:
•
If possible, use existing through-holes for feeding through the connection cables, or other suit-
able options, such as ventilation grilles. If there are no existing through-holes, you must drill a
hole of ∅ 22 mm. Check beforehand that there is sufficient space on the other side for the drill
head to emerge (fig. 2, page 4).
EN
Description
Monitor
20-pin socket
Monitor line
20-pin plug
12 – 24 V positive cable (red): connected to the positive terminal of the
ignition (connected positive, terminal 15) or the positive terminal of the bat-
tery (terminal 30)
Earth cable (black): connected to the negative terminal of the voltage
source
Cable (green): control input for video input AV1,
such as for connecting the reversing light
Cable (white): control input for video input AV2,
such as for the side camera
6-pin AV1 socket (connection to video source 1)
6-pin AV2 socket (connection to video source 2)
6-pin AV3 socket (connection to video source 3)
6-pin AV4 socket (connection to video source 4,
with video signal detection)
Cable (blue): control input for video input AV3
Installing the LCD monitor
15