Dometic MAGICCOMFORT MSH60 Instrucciones De Montaje Y De Uso página 14

Installing the seat heater
Installing the heating element for the seat surface
A
NOTICE!
The heating cables must not be damaged or bent sharply. In case you
need to make cuts in the heating element, pay attention to the routing of
the heating cables.
➤ Insert the heating element for the seat surface between the cover fabric and the
foam core of the seat (fig. 0, page 5).
I
NOTE
To bridge the stitching recesses or the cross braces with which the seat
cover is additionally secured to the foam core, a recess is provided on
the heating element of the seat surface.
➤ Depending on the seat, guide this area through the stitching recess (fig. a,
page 5) or place this area through the recesses in the tunnel for the cross braces.
➤ Fasten the heating element using double-sided adhesive tape to prevent it
sliding on the foam core.
Ensure that no creases or kinks form.
Installing the heating element for the backrest
➤ Open the lower area of the backrest cover (fig. b, page 5).
➤ Push the heating element into the gap between the seat cover and the seat
cushion (fig. c, page 5).
➤ Fasten the heating element using double-sided adhesive tape to prevent
creases.
I
NOTE
The heating surface only needs to extend approx. 30 – 35 cm above the
seat, as the driver, when sitting normally, leans against this area only.
If the seats are equipped with side airbags, then there is a predeter-
mined breaking point in the cover fabric. The seat cover must therefore
not be pulled tightly or slip out of place.
Installing the seat
➤ Lift the seat into the vehicle.
➤ Secure the vehicle seat with the fastening screws.
14
MSH60, MSH601
EN