Installing The Handle; Rules For Safe Operation - IKRA BT 2335 Instrucciones De Manejo

• Keep your body warm, especially the head, neck,
feet, ankles, hands and wrists. Maintain good blood
circulation by performing vigorous arm exercises dur-
ing frequent work breaks and also by not smoking.
• Limit the hours of operation. Try to fill each day with
jobs where operating the brush cutter or other hand-
held power equipment is not permanently required.
• If you experience discomfort, redness and swelling
of the fingers followed by whitening and loss of feel-
ing, consult your physician before further exposing
yourself to cold and vibration.
• Always wear ear protection, loud noise over a long-
er time may make cause hearing defects or even
deafness.
• Full face and head protection must be worn to pre-
vent injuries from falling objects or branches.
• Wear grip-safe heavy-duty work gloves to improve
your grip on the brush cutter handle. Gloves also re-
duce the transmission of vibrations to your hands.
• WARNING: The operating range of the cutter is still
dangerous while the device is coasting to a halt.
ASSEMBLY
INSTALLING THE PROTECTION COVER
BRACKET
M5x25
SCREWS
Install the safety guard at the tube using the holder
and the 2 screws. Put the safety guard in the correct
position and tighten the screws.
INSTALLING NYLON LINE CUTTING HEAD
WARNING ATTENTION
JOINING PIECE
PROTECTION COVER
JOINING PIECE
NYLON LINE CUTTING HEAD
Screw the cutting head on the threaded bolt of the join-
ing piece turning it clockwise until it is tightly fixed.

INSTALLING THE HANDLE

Remove the 4 screws from the included handle. Put
the lower part of the handle on the rubber collar that is
already seated on the shaft. The rubber collar serves
to absorb vibrations developing when working with the
trimmer. Make sure that the extension of the lower part
of the handle points to the left side of the shaft. Now
put the upper part of the handle on the lower part and
connect both using the 4 pertaining screws. Install the
handle on the shaft such that the minimum distance
between the rear handle and the front handle is 25
cm.

RULES FOR SAFE OPERATION

WARNING DANGER
All trimmers and brush cutter models may throw small
stones, metal or other small objects as well as cut-off
matter. Therefore you should read these 'Rules for
Safe Operation' carefully. Follow the instructions in
your Operating Instructions.
Read the Operating Instructions carefully. Familiar-
ize with the control elements and proper use of the
unit. Learn how to stop the unit and shut off the en-
gine. Learn how to unhook a harnessed unit quickly.
Never permit other persons to use the unit unless they
have been properly instructed. Make sure the operator
wears proper foot, leg, eye, face and hearing protec-
tion. Do not rely on the unit's protection cover to protect
your eyes from ricocheting or thrown objects. Keep the
working area clear of bystanders, children and pets.
Never allow children to operate or play with the unit. Do
not allow anyone to enter the DANGER ZONE when
operating the unit. The danger zone is an area of 15
meters in radius (about 16 steps) or 50 feet around
the operator.
Insist that persons within the RISK ZONE beyond the
DANGER ZONE wear safety goggles to protect their
eyes from thrown objects. If the unit must be used in
areas where there are unprotected people, operate it
at a low speed to reduce the risk of thrown objects.
The device may only be operated with the stop switch
being in proper condition.
WARNING DANGER
In addition to head, eye, face and ear protectors, shoes
to protect your feet improve your footing on slippery
surfaces. Do not wear ties, jewellery, or loose, dan-
gling clothing that might get caught in the unit. Do
GB-4