First Menu Level - General Settings - WIKA CTD4000 Manual De Instrucciones

7. Operating the calibrator

7.3.2 First menu level - General settings

▶
By pressing the [F] button, menu level 1 is accessed.
▶
With the [F] button, the menu functions can be scrolled through.
EN
Function Meaning
SP Set point
Setting the set temperature.
1. With the [▲] or [▼] button, set the set point.
2. Confirm the entry with the [E] button.
SEt2 Set point 2
Setting of set temperature 2, which the calibrator should approach with a certain gradient within a ramp.
1. With the [▲] or [▼] button, set the set point 2.
2. Confirm the entry with the [E] button.
Grd Gradient
Heating or cooling change rate during the change of the temperature value SP to SEt2 or SEt2 to SP.
1. With the [▲] or [▼] button, set the gradient.
2. Confirm the entry with the [E] button.
run Switch test
1. With the [▲] or [▼] button, select ON or OFF.
2. With the [E] button, start or stop the switch test.
The temperature dry-well calibrator reaches temperature SP2 from SP with the selected heating rate of
change. The basis is the same temperature with which the ramp was confirmed. If the value of SP2 is lower
than the SP, the calibrator will not accept the run and the instrument will display "Err". The LED will flash to
indicate that the function is active. The set point will change the value following the selected slope rate. When
the internal temperature reaches the SEt2 set point, the internal temperature will decrease with the cooling
slope rate; the SP value will be considered as the new set point. During the ramp program, the derivative
parameter will not be considered. During the ramp program, the LED on the right of the set point flashes and
the set point increases or decreases the value.
20
The value of SEt2 must be always higher than SP.
The gradient must be smaller than the maximum specified value in the technical specifications (max.
15 °C/min).
WIKA operating instructions, model CTD4000