Connecting The Ma & Contact Terminal Interface To The Indoor Unit - Mitsubishi Electric MAC-397IF-E Manual De Instalación

2.2. Parts
Before installing the unit, make sure that you have all the necessary parts.
■ Accessory
1
Interface unit (with 5-core connecting cable)
2
Wall mounting bracket
3
Screws for mounting 2 3.5 × 12
4
Cushioning material (with adhesive)
5
Mounting cord clamp (small)
6
Mounting cord clamps (medium)
7
Mounting cord clamp (large)
Screw for mounting 5–7 3.5 × 12
8
* Use when attaching the clamps to the interface unit
Screw for mounting 6 4 × 10
9
* Use when mounting the clamps near the M series
Screw for mounting 6 4 × 16
0
* Use when mounting the clamps and electrical wire
mounting bracket
A
Cable ties
B
Fasteners (for joining the lead wires)
C
Cord clamps for wiring
D Screws for mounting C 3.5 × 12
E Screws 3.5 × 12 (Spare)
F
Lead wires (6)
3. Connecting the MA & CONTACT Terminal Interface to Indoor Unit
• Connect the interface unit and the indoor control board using the connecting cable that comes with the interface.
• Extending or shortening the connecting cable that comes out of the interface may cause it to malfunction. Also, keep the
connecting cable as far as possible away from the electrical wires and ground wire. Do not bundle them together.
M series
Indoor unit
Indoor control board
P/S series
Indoor unit
Indoor control board
• When this interface unit is connected with the indoor unit, timer operation cannot be set from a wireless remote controller.
• When this interface unit is connected with the indoor unit, i-see sensor control cannot be used. Normal cooling or heating
operation is performed. (MSZ-FA Series only)
4
■ Items to Be Prepared at the Installation Site
1
A
Signal wires (also used as extension wires)
1
Remote control wires (for connecting the MA Remote Controller)
B
2-core wire between 0.3 and 1.25 mm
4
Switch, relay, coin timer, etc. (if necessary)
1
C
* Please use products with supplementary insulation.
1
Use wires which have insulation more than the MAX voltage.
2
* MAX voltage is defined according to the law of the country where
1
the interface is used.
1
1
1
3
3
3
3
2
1
Connect the connecting cable that comes with the
interface unit to the connector CN105 on the indoor
control board.
Connect the connecting cable that comes with the
interface unit to the connector CN92/CN105 on the
indoor control board.
2
Interface unit 1
Interface unit 1