Tabla de contenido
Idiomas disponibles
Idiomas disponibles
The
always be looked after!
Before leaving the working area
you have to turn off the machine
and wait till the motor and the
saw blade are standing still.
Never look directly into the la-
ser. Do not turn the laser to-
wards reflecting surfaces, ani-
mals or people.
Only
suitable saw blades.
Change damaged saw blades
immediately.
Blunt saw blades increase the
danger of kickback!
Do not overload the machine.
9 STARTING UP
9.1
Included in delivery ZI-
KGS210 (Fig. B)
Unpack the ZIPPER mitre saw and check
the machine for any transport damage
and for completeness of delivery.
Accessories:
(E)
Allen wrench
(F)
Hex driver
(G)
Carbon brush 2x
(H)
Operation manual
9.2
Assembly (Fig. C)
· Insert the batteries for the laser (A)
· Mount the two work piece supports (B)
· Insert the work piece binder (C)
· Mount the dust collector bag (D)
· Assemble the lever for the angle lock
(E)
· Fix the saw on the ground (work bench
/ machine stand)
running
machine
use
for
the
ZI-KGS210
must
9.3
The maximum cutting depth results from
the deepness of the cutting line. The saw
blade must not touch the machine bed
anytime!
The recommended cutting depth is 5mm
under the upper edge of the work piece
support (Fig. D).
Adjust
analogous (Fig. G). After that you have to
lower the saw aggregate to the lowest
position and turn the saw blade with the
hands to test the free run.
For groove cuts (the material is not cut
completely) you must swing out
deepness limitation so that the deepness
limitation screw rests on it when lowering
the saw aggregate. Adjust this screw.
9.4
Cutting angles are factory setted. For
precision mitre cuts you have to adjust
the angle adjustment on the fence and the
mitre angle. After long operation you have
to control this regularly.
9.4.1
· Set the saw aggregate to the 0° posi-
· Lower the saw aggregate to the low-
· Fix the aggregate in this position by
· Pull the saw aggregate forwards so
· Fix the aggregate in this position.
A T T E N T I O N
FORBIDDEN: Adjustments when
the machine s connected with
the power supply!
Injuries and material damages
by unintentional starting!
So
always
disconnect
machine from the power supply
before adjusting works.
Make sure that all the screws,
levers, etc are fastened well and
that
loose
tools
removed
from
before operation.
Adjusting the cutting
depth
the
deepness
Angle adjustment
Angle adjustment
tion.
est position.
latching the lock pin (from the right
side in front of the machine).
that it rests on the fences.
EN
the
have
been
the
machine
limitation
2
the
Tabla de contenido
Solución de problemas
