Assembly; Operation - Ryobi P714 Manual Del Operador

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the following purpose:
 Light-duty vacuuming of dry surfaces
 Household type
INSTALLING/REMOVING BATTERY PACK
See Figure 1 - 2, page 6.
 Place the battery pack in the hand vac. Align the raised rib
on the battery pack with groove in hand vac's battery port.
 Make sure the latches on each side of the battery pack
snap in place and that the battery pack is secured in the
hand vac before beginning operation.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.

OPERATION

 Locate the latches on the side of the battery pack and depress
both sides to release the battery pack from the hand vac.
NOTE: It is not necessary to remove the battery pack from
the tool to recharge.
 With the battery installed, place the tool in the wall-
mounted charger by aligning the raised ribs on the tool
housing with the grooves in the charger as shown.
 Slide the tool down until it is fully seated on the charger.
NOTE: The LED indicator will flash quickly to evaluate,
intermittently while charging and will fade in and out when
fully charged.
STARTING/STOPPING THE VACUUM
See Figure 3, page 6.
 To start the vacuum: press the ON/OFF button.
 To stop the vacuum: press the ON/OFF button.
REMOVING/REATTACHING THE DUST BOWL
See Figure 4 - 5, page 6.
The dust bowl should be checked, emptied, and cleaned
periodically for maximum dust collection.
To remove:
 Remove the battery pack.
 Push forward the release button located on top of the
hand vac. Pull the dust bowl down and out.
To reattach:
 Position the two sections as shown. Align the slot on the
bottom of dust bowl with the tab on the bottom of motor
housing, then snap the two sections together.
4 — English