EGO Power+ LM2020SP Manual De Operaciones página 32

REPLACING THE TRAILING SHIELD
WARNING: Always remove the battery pack when servicing
or transporting the mower.
WARNING: Never operate the mower unless the trailing
shield is in place and working. Never operate the mower with
damaged safety devices. Failure to do so can result in personal
injury. The trailing shield is subject to wear and damage, which
could expose moving parts or allow objects to be thrown. For
safety protection, frequently check the trailing shield and replace
it immediately with only the identical replacement part, listed in
this manual.
1. Remove the battery.
2. Turn the mower on its side with the upper surface against
a wall.
3. Remove the rear wheel on the top side, following the
section "REPLACING THE WHEELS" in this manual.
4. For self propel mower LM2020SP, loosen the wheel cover
locking screw and remove the screw, spring washer and
flat washer in that order, then remove the wheel cover from
the wheel shaft (Fig. 33).
5. Repeat steps 1 to 3 above to remove the other rear wheel
and wheel cover (LM2020SP only).
6. Loosen the locking screw for the trailing shield on both
sides; remove the worn trailing shield and the flat washer.
Save the washer for reassembly (Fig. 34a & 34b).
32
56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2020SP/LM2020
33
Wheel Cover
Locking Screw
34a
Locking Screw For
Trailing Shield
For LM2020SP
34b
Locking Screw For
Trailing Shield
For LM2020
Wheel Axle
Trailing shield
Trailing shield