Maintenance And Care - Schumacher Electric CR1 Manual Del Usuario

QUICK CHARGE
When the CHARGED
charger from the wall outlet and then disconnect the charger from the battery. NOTE:
The CHARGING
COMPLETE CHARGE
Charge completion is indicated by the CHARGED
charger has switched to the maintain mode of operation. When ready to use, unplug
the charger from the wall outlet and then disconnect the charger from the battery.
CHARGING TIMES
Complete charge will usually take between 3-6 hours. Times may vary, depending
on the battery's level of discharge.
NOTE: For longer battery life, the battery must be completely charged after two
consecutive quick charges (example: quick-quick-complete).
MAINTAIN MODE (FLOAT-MODE MONITORING)
When the CHARGED
mode. In this mode, the charger keeps the battery fully charged by delivering a
small current when necessary.
ABORTED CHARGE
If charging cannot be completed normally, charging will abort. When charging
aborts, the charger's output is shut off, and the CHARGING
LED will flash. To reset after an aborted charge, unplug the charger from the AC
outlet, wait a few moments and plug it back in.

11. MAINTENANCE AND CARE

11.1 After use and before performing maintenance, unplug and disconnect the battery
charger.
11.2 Use a dry cloth to wipe all battery corrosion and other dirt or oil from the connector,
cords and the charger case.
11.3 Store inside, in a cool, dry place.
LED begins to flash, the battery is ready to use. Unplug the
LED will remain lit while the CHARGED
(green) LED is pulsing, the charger has started maintain
• 9 •
LED is flashing.
(green) LED. When pulsing, the
(yellow/orange)