Tabla de contenido
Idiomas disponibles
Idiomas disponibles
OPERATION
CAUTION:
Always hold the base flush with the workpiece.
•
Failure to do so may cause blade breakage,
resulting in a serious injury.
Advance the tool very slowly when cutting curves or
•
scrolling. Forcing the tool may cause a slanted
cutting surface and blade breakage.
1
012319
Turn the tool on without the blade making any contact
and wait until the blade attains full speed. Then rest the
base flat on the workpiece and gently move the tool
forward along the previously marked cutting line.
Bevel cutting
012320
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before tilting the base.
Raise the dust cover all the way before making
•
bevel cuts.
012321
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
1. Cutting line
2. Base
2
1. Hex wrench
1
2. Bolt
3. Base
2
3
Loosen the bolt on the back of the base with the hex
wrench. Move the base so that the bolt is positioned in
the center of the cross-shaped slot in the base.
1
012322
Tilt the base until the desired bevel angle is obtained.
The edge of the motor housing indicates the bevel angle
by graduations. Then tighten the bolt to secure the base.
Front flush cuts
1
012323
Loosen the bolt on the back of the base with the hex
wrench and slide the base all the way back. Then tighten
the bolt to secure the base.
Cutouts
Cutouts can be made with either of two methods A or B.
A) Boring a starting hole
1
012324
For internal cutouts without a lead-in cut from an
edge, pre-drill a starting hole 12 mm or more in
diameter. Insert the blade into this hole to start your
cut.
7
1. Edge
2
2. Graduation
1. Bolt
2
2. Hex wrench
3. Base
3
1. Starting hole
Tabla de contenido
