Daewoo DTD 5500 Manual De Instrucciones página 35

code is 0000). Press
NOTE: If there are two or more handsets registered with the same base. In idle mode, press INT key, the LCD
displays the registered handsets' number and digit of "9", then press "9" on the keypad to page the all
registered handsets when difficult to look for.
One-touch Memory (on BASE)

Store the number into one-touch memory
1) In on-hook state, pre-dial a number or scroll to the desired incoming number
Press and hold Mi (i=1~7) for 2 seconds, with a "DI DU" sound being heard, the number is stored.
2)

Dial out number from one-touch memory
In on-hook or off-hook state, press Mi (i=1~7) key, the number is dialed out.

Delete one-touch memory
In on-hook state, press # key twice, then press and hold Mi (i=1~7) key to delete it.
Use a Multi-handset System
To make intercom calls
1) In idle mode or in off-hook state, press INT key. If you have only one cordless handset registered to
the base, the display will show "CALLING HS1" and the base will beep.
If you have more than one handset registered to the base, the display will show "HS?" with the
registered handset numbers above and the base will output a continuous beep, until you press the
number for the handset you want to intercom. Then the display will change, for example, to
"CALLING HS2", if it is handset 2 that is being called.
The handset being called will ring with its selected melody and display "BASE CALLING".
2)
Receiving an intercom call from a cordless handset
When the phone rings and the display shows "HS1 CALLING", you can answer the call by pressing the
key or picking up the handset.
If you want to end the intercom, press the
To transfer a call
1) During an external call, if you want to transfer the call to a cordless handset, press the INT key. The
external call will be put on hold. If the base has only one cordless handset registered it will
immediately start calling that handset, but if more than one handset is registered enter the number for
the handset you want to transfer the call to.
2) When the handset answers the intercom call, simply hang-up at the base to transfer the call. If the
handset does not answer within 30 seconds, the transfer will be cancelled and the external call
reconnected to the base.
Receive a transfer call from a cordless handset.
When you have an intercom call transfer your base will ring and the display will show "HS1 CALLING"
To answer the call, pick up the handset or the
To set up a three-way conference
1) During a call, press INT key and enter the number of the handset you want to connect by using the
key to confirm, and the display will flash "SEARCHING 1"(or 2,3,4)
key or replace the handset.
key and you will be connected.
35