7
Cleaning and Storage
1. Store thermometer in a dry location free from dust and contamination and away
from direct sunlight. The ambient temperature at the storage location should remain
fairly constant and within the range of -25 C to 55 C.
2. Use an alcohol swab or cotton swab moistened with alcohol (70% Isopropy)
to clean the thermometer casing and the measuring probe. Ensure that no liquid
enters the interior of the thermometer.
3. Never use abrasive cleaning agents, thinners or gasoline for cleaning and never immerse the
instrument in water or other cleaning liquids. Take care not to scratch the surface of the probe
lens or display.
Replacing the batteries
1. When voltage of the battery is low, the LCD will display "
battery in the unit. The thermometer cannot work accurately under the condition of low voltage.
2. The thermometer is supplied with a 3 V LITHIUM BATTERY (CR 2032), Insert a new battery when
the low voltage symbol appears on the LCD.
3. Remove the battery cover and pull down the metal button(see Fig),the battery will be bounced
out, then you can take out the old battery.
4. Place a new battery, the positive pole "+ " up and negative pole " - " down.
5. Please take out the battery to avoid battery leaking if unit not used for over six months.
6. The disposal of the battery and the device shall comply with the local environment requirements.
Disposal: The product must not be disposed of along with other domestic waste.
point for electric and electronic equipment.
For further information on recycling points contact the local authorities, the local
recycling center or the shop where the product was purchased. If the equipment
the national legislation and regulations.
GIMA WARRANTY CONDITIONS
Congratulations for purchasing a GIMA product.
This product meets high qualitative standards both as regards the material and the production.
The warranty is valid for 12 months from the date of supply of GIMA.
During the period of validity of the warranty, GIMA will repair and/or replace free of charge all
the defected parts due to production reasons. Labor costs and personnel traveling expenses
and packaging not included.
All components subject to wear are not included in the warranty.
The repair or replacement performed during the warranty period shall not extend the warranty.
The warranty is void in the following cases: repairs performed by unauthorized personnel or
with non-original spare parts, defects caused by negligence or incorrect use.
GIMA cannot be held responsible for malfunctioning on electronic devices or software due
The warranty is void if the above regulations are not observed and if the serial code (if available)
has been removed, cancelled or changed.
The defected products must be returned only to the dealer the product was purchased from.
Products sent to GIMA will be rejected.
ENGLISH
" symbol, please replace a new
lds, radio interferences, etc.