Troubleshooting Guide - Hamilton Beach 908 Serie Manual De Uso

Caring for the Blender

Troubleshooting Guide

Problem . . .
Blender fails to start
or stops while it is
running and cannot
be restarted
Ingredients will not
mix properly
Maintenance
Inspect the blender and its various parts and replace as follows:
Daily Unplug the blender, remove the container from the base, and then inspect the container
and cutter unit assembly for wear, nicks, and broken or loose blades. Replace if
necessary. If the blades are loose, discontinue use immediately and replace the blades.
Do not attempt to repair or tighten the cutter assembly. See "Replacement Parts" below.
Weekly Unplug the blender, and then inspect the power cord insulation and power plug for
cracks. Refer to "Technical Services" on page 2 for repair or replacement.
Quarterly Replace the container and cutter assembly at least every 90 days. See "Replacement
Parts" below.
Replacement Parts for Model HBB908
For replacement parts, call toll-free: 866-285-1087.
Part Description
44-oz. polycarbonate container
Cutter assembly
Solution . . .
• Check to see if unit is securely plugged into an electric outlet.
• Check to see if the fuse for the electric outlet has blown or if a circuit breaker
has tripped.
• If the motor stops during operation due to overheating, unplug and allow the
blender to cool down for 15 minutes. Plug blender back in after 15 minutes to
resume normal operation.
• Check to see if enough liquid has been added to the ingredients. Mixture should
be fl uid and free-running at all times.
• Solid pieces are too large. Pieces should not exceed 1ʺ (25-mm) cubes.
• Container is too full. Do not fi ll past highest graduation marking.
• Cutter unit blades are not sharp or are damaged. Inspect container and cutter
assembly daily. Replace cutter assembly at least every 90 days or sooner if
cutter assembly appears worn or damaged.
• Check to see if cutter assembly is installed properly.
• Select speed to create a fl uid blend.
Part Number
6126-HBB908
98908
9