RIB SUPER 6000 Manual De Instrucciones página 31

A - CONNEXIONS
IT IS COMPULSORY TO SET THE
DIP 13 OF THE CONTROL PANEL
IN THE ON POSITION.
T1
T2
T T R S T N U
JA
3-PHASE LINE
400V + N
MOTOR
3 P
J1 L1 - N 230Vac 50/60Hz POWER SUPPLY
BLINKER (40 W MAX.)
J2 U-V-W CONNECTION TO JC CONTACTS OF THE CARD R2
J3 PED. BUTT. PEDESTRIAN OPENING CONTACT (NO)
A+ TEST +24Vdc SAFETY STRIP SELF-TEST POWER SUPPLY
LSC CLOSE LIMIT SWITCH THAT CUTS OFF THE MOTOR IN CLOSING
COM LIMIT SWITCH COMMON CONTACT
LSO OPEN LIMIT SWITCH THAT CUTS OFF THE MOTOR IN OPENING
J4 STOP STOP CONTACT (NC)
OPEN OPENING CONTACT (NC)
CLOSE CLOSING CONTACT (NC)
K. BUTT. SINGLE PULSE CONTACT (NO)
A+ ACCESSORIES POWER SUPPLY +24Vdc
A- ACCESSORIES POWER SUPPLY -24Vdc
SIGNAL GATE OPEN INDICATOR 24Vdc
COM COMMON CONTACT (common line for all the command and
safety inputs)
EDGE NC SAFETY STRIP CONTACT (NC)
J5 AERIAL RADIO ANTENNA
COM COMMON CONTACT (common line for all the command and
safety inputs)
PHOTO NC PHOTOCELLS CONTACT (NC)
S3
J5
TR1
TR2
J4
J3
J2
V W
J1
PTO
J7 J6
SW
RADIO
J8
SW1
SW2
SW3
SW
S1
J6 PROBE IS NOT AVAILABLE
J7 ENCODER IS NOT AVAILABLE
J8 RADIO CONNECTOR FOR EXTERNAL RADIO RECEIVER 24Vdc
S3 PROG. PROGRAMMING BUTTON
TR1 LOW SPEED IS NOT AVAILABLE
TR2 TORQUE IS NOT AVAILABLE
SW (only CRX control board) DO NOT REMOVE ANY JUMPER!
OTHERWISE THE OPERATOR WILL NOT WORK!
RADIO
SW S1 DO NOT REMOVE THE JUMPER! OTHERWISE THE OPERATOR
WILL NOT WORK!
SW1 DIP-SWITCHES
SW2
SW3
CARD R2
T1 - T2 T POWER RELAYS FOR THE COMMAND OF THE MOTOR
JA R-N SINGLE PHASE POWER SUPPLY - NEUTRAL
CONTACTS FOR THE EARTH CONECTION
U-V-W MOTOR CONNECTION
31
INNER THERMAL OVERLOAD CUT-OUT
SWITCHES (per CEI 2-3/IEC 34-1)
The electrical protections on the SUPER 6000
motor power line may not be sufficient to protect
against overloads. If the cooling conditions worsen,
the motor overheats but the electrical conditions
do not change, which inhibits line protections.
Installing the bimetallic device PTO on the
S1-CRX/R4 control panel solves this problem.
This is a normally-closed electromechanical device
that opens when the threshold
temperature is reached; it
automatically resets when the
temperature falls below the
threshold level.
T
NC: NORMALLY CLOSED CONTACT
NO: NORMALLY OPEN CONTACT
G
B
T