Declaration Of Conformity - Beta 1901T/10 Manual De Uso E Instrucciones

USE
Air/water supply connection
Connect the hose reel to the air/water supplier through the input pipe (picture 1-d). Use a fitting like item Beta 1918-10 (picture 3). Do
not use any fittings (picture 4) that may damage the supply pipe. For correct use of the automatic hose reel, always keep to a maximum
pressure of 15 bars. Excessively high pressure may cause damage or injury.
Hose reel adjustment
The automatic hose reel is fitted with a spring winding system with automatic locking at the required length. Adjust the hose winding
limiting device as needed.
Hose pulling
Pull the hose as follows:
– pull the hose by hand until the required length is achieved;
– the hose is locked by means of the spring ratchet, which is activated in certain pulling points of the hose, which can be heard
through the mechanical noise of the engaged ratchet;
– the automatic safety catch locks the hose, thereby preventing it from winding completely and rapidly.
Hose winding
Wind the hose as follows:
– pull the hose by hand to automatically release the ratchet;
– ease the hose while winding it, being careful to avoid interference with persons or things;
– the hose is fitted with a hose winding limiting device which stops it, thereby preventing it from winding completely.
Safety catch disconnection
The safety catch of the hose reel can be cut out as follows:
– open the side cover on the hose reel by unscrewing its fixing screws;
– release the ratchet spring from fixing point 1 and hook it to fixing point 0;
– put back the cover, replacing and tightening the screws correctly. During this operation, the hose must be completely rewound.
Always disconnect air supply before carrying out any jobs on the hose reel.
Lubrication
The hose reel should be connected to a compressed air supply system complete with filtering system for solid particles, if need be.
MAINTENANCE
Maintenance and repair jobs must be carried out by trained personnel. For such jobs, you can contact Beta Utensili S.P.A.'s repair
centre.
DISPOSAL
The hose reel must be disposed of in accordance with the law provisions in force in the country where it is used.
WARRANTY
This equipment is manufactured and tested in accordance with current EU regulations. It is covered by a 12-month warranty for
professional use or a 24-month warranty for nonprofessional use.
We will repair any breakdowns caused by material or manufacturing defects, by fixing the defective pieces or replacing them at our
discretion.
Should assistance be required once or several times during the warranty period, the expiry date of this warranty will remain unchanged.
This warranty will not cover defects due to wear, misuse or breakdowns caused by blows and/or falls.
In addition, this warranty will no longer be valid if any changes are made, or if the pneumatic tool is forced or sent to the customer
service in pieces.
This warranty explicitly excludes any damage caused to people and/or things, whether direct or consequential.
We hereby declare, assuming full responsibility, that the described product complies with all the relevant provisions of Machine
Directive 2006/42/EC and amendments thereto, as well as with the following standard:
• EN ISO 12100
The Technical Brochure is available at:
BETA UTENSILI S.P.A.
Via A. Volta 18 - 20845 Sovico (MB) - ITALY
Name and title of person in charge
MASSIMO CICERI
(Managing Director)
BETA UTENSILI S.P.A.
Via A. Volta 18
20845 Sovico (MB)
ITALY

DECLARATION OF CONFORMITY

Date 01/01/2015