M.-Nr. 05719362
Installation instructions for payment systems C4060, C4065, C4070
Parts included
Quantity Mat. no.
Designation
1
Payment system
1
Rubber mat
4
M6x25 bolt
1
Strain relief
8
B6.4 galvanized washer
4
M6 nut
4
M6x25 bolt
4
Raised-head self-tapping screw 4.2 x 9.5
1
Sticker
1
Information sheet "Connection information for C4065/C4070" payment systems (with a C4065 or
C4070 payment system)
A number of tokens (depending on model)
Danger due to incorrectly carried out service and repair work
WARNING
Danger due to incorrectly carried out service and repair work.
There is a risk of serious damage, injury and even death if service and repair work is carried out incorrectly.
A
Service and repair work should only be carried out by a suitably qualified electrician with specialist training,
knowledge and experience.
A
All appropriate safety regulations must be taken into account.
A
Read the technical service documentation (TSD) before starting service work.
Risk of cuts
CAUTION
Components are sharp.
Risk of cuts.
A
Protective gloves should be worn and the edge protection, mat. no. 05057680, should be used.
PW 5065, PW 6055, PW 6065, PW 6080, PT 5135 C, PT 5136, PT 7135 C, PT 7136, PT 7186
For safety reasons the connection cable must not exceed 2.5m in length.
A
Place the supplied rubber mat on the machine lid and align it with the edges of the machine lid with W = 35mm and
Z = 80mm.
This serves as the drilling template; see Fig. 1.
A
Drill 6.5mm diameter holes; see Fig. 1.
A
Open the front panel of the payment system.
A
Line up the rubber mat (1) over the pre-drilled holes; see Fig. 2.
A
Secure the payment system to the machine lid using the supplied fixing materials.
A
Push out the pre-punched feed-through hole in the back panel.
A
Connect the cable (3) to the 7-pin plug in the machine; see Fig. 2.
A
Attach the strain relief (2); see Fig. 2.
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
23 von 56
21.12.2017
