Check Scope Of Delivery; Assembly - Zipper Maschinen ZI-MOS125 Manual De Instrucciones

15

ASSEMBLY

Check scope of delivery

After delivery, check the machine immediately for transport damage and missing Parts refer to
Fig. B1 and B2.
Assembly
Fig. C2:
Put the bottom connector (5) on the motor
unit (2) so that the 4 holes line up.
Fig. C2.2:
Insert the mounting frame (1) of the
cutting head and the cutting protection
console on the guide rail. Pay attention to
the cover the 4 holes.
Fig. C2.3:
Tighten with allen key (I2) the holder
frame (1) and Holm Up (6) with the 4
screws (S2) firmly.
Fig. C3:
Mount the mowing protection (4) onto the
mowing pole. Place the four screws (S1)
through the
protection collet as shown in Fig. C3 and
place the mowing protection (4) onto the 4
screws as shown in Fig. C4
Fig. C4:
Fix the mowing protection by tightening the
four nuts (M1) with the open end wrench
onto the screws. Use the borings as shown
in picture C4!
Fig. C10:
After having mounted together all major disassembled parts of the machine, you can adapt the
operation pole assembly according to your body height!
Loosen the 4 hex headscrews that tighten the green pole collet onto the crosspole of the
frame(1). Adjust the pole assembly in a way that you can hold, staying upright, the steering
handle conveniently with your arms being moderately angled.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-MOS125
borings of the mowing
Fig. C5:
Mount the trimmer limiter (P) with the screw (S4)
by tightening it with the Phillips screwdriver (K).
Fig. C6:
Slip one wheel onto the wheel axis on the side of
your choice. Slip two washers (BR) onto that axis
and finally tighten the wheel with the lock nut
(MR) so that the wheel can still rotate freely.
Fig. C7.1-C7.6
Mount the Swiveling device like in Fig. C7.1 –
C7.6.
Fig. C7.7:
Loosen the hex head srews of the green pole collet
of the frame(1) with allen key (I1) as much as
possible.
Insert the pole (3) into the collet. Take care that
the support wheel is situated towards the ground!
Tighten the hex head screws again.
Fig. C8:
Now you connect the operation pole (10) to the
pole with the support wheel (3).
First, you have to slip the connecting frame (14)
onto the pole (3) and connect these two parts with
one hex head screw (S6).
Then, you insert the operation pole into the
connecting frame. Dependent on your preference
regarding with which hand you prefer to operate
the throttle lever you can choose how to insert the
operation pole. Fix it as well to the connection
frame (14) with a hex head screw (S6).
Fig. C9:
Finally, insert the two pieces of black hex head
screws into the connecting frame borings and
fasten them firmly to tighten the entire pole
assembly together!
ASSEMBLY
28