Stacked Installation (Example Of 1 Or 4 Vio-L210 On Sub318) - dBTechnologies VIO S318 Manual Del Usuario

English

STACKED INSTALLATION (EXAMPLE OF 1 or 4 VIO-L210 ON SUB318)

• For safety reasons, a maximum of 4 modules can be assembled in stacked configuration
on DRK-210 fly-bar.
• Use DBTECHNOLOGIES COMPOSER to set project parameters.
• Position DRK-210 fly-bar (step A) on SUB 318 (installed on a flat surface). For further
details on this accessory, refer to the complete manual.
• Add VIO-L210 modules one by one, with the previously-calculated angle, as shown in
MECHANICS paragraph.
• Make sure that the local parameters of the different modules and subwoofers are
correctly set on the single amplifier panels. As an alternative, all parameters can be
remotely edited in real time or at a later stage in case of line-array connection through
the RDNet network (DBTECHNOLOGIES NETWORK). Nevertheless, project initial settings
should at least be physically repeated on the VIO-L210 modules before installation. For
further informations please see
• Make the audio daisy-chain, RDNet and power connections as described in previous
paragraphs (step B).
FRONT
VIO-S318
CONFIGURATION PARAMETERS
A
section.
REAR
Cod. 420120244 REV. 1.1
47