Specific Safety Information; Press Tool Safety; Description, Specifications And Standard Equipment Description; Specifications - RIDGID RP 200-B Manual De Instrucciones

RP 200-B Press Tool

Specific Safety Information

WARNING
This section contains important safety information
that is specific to this tool.
Read these precautions carefully before using the
RP 200-B Press Tool to reduce the risk of electri-
cal shock or serious personal injury.
SAVE THESE INSTRUCTIONS!
A compartment in the RP 200-B carrying case is included
to keep this manual with the machine for use by the oper-
ator.

Press Tool Safety

• Use the RP 200-B Press Tool only with RIDGID
Com pact pressing attachments (jaws, press ring,
actuator, etc.). Other uses or modifying the RP 200-B
Press Tool for other applications may damage the
press tool, damage the attachments and/or cause
personal injury.
• Keep your fingers and hands away from pressing
attachments during press cycle. Your fingers or
hands can be crushed, fractured or amputated if they
become caught between the jaws or between these
components and any other object.
• Never attempt to repair damaged jaws, press ring,
actuator or other attachments. An attachment that
has been welded, ground, drilled or modified in any
manner can shatter during pressing resulting in serious
injury. Discard the entire damaged jaws. Replace with
new jaws. Never replace individual components except
for damaged jaw return springs. Please call Ridge
Tool Company, Technical Services for availability.
• Before operating a RIDGID Tool, Read and under-
stand:
– This operator's manual,
– The attachment instructions,
– The battery/charger manual,
– The fitting manufacturer's installation instructions,
– The instructions for any other equipment used with
this tool,
Failure to follow all instructions and warnings may
result in property damage and/or serious injury.
If you have any question concerning this RIDGID
– Contact your local RIDGID
– Visit www.RIDGID.com or www.RIDGID.eu to find
your local Ridge Tool contact point.
– Contact RIDGID ® Technical Services Department at
[email protected], or in the U.S. and
Cana da call (800) 519-3456.
4
®
® product:
® distributor.
Description, Specifications
And Standard Equipment
Description
The RP 200-B Press Tool, when used with appropriate
jaws, is designed to mechanically press fittings onto tubing
to create a water-tight and permanent seal. When the
switch on the RP 200-B is depressed, an internal electric
motor powers a hydraulic pump which forces fluid into
the cylinder of the tool, forcing the ram forward and apply-
ing thousands of pounds of pressing force onto specially
designed fittings. Attachments are also available for other
uses.
The entire cycle duration is approximately four (4) sec-
onds. Once the cycle begins to deform a fitting, it will auto-
matically continue until completion, even if the trigger
switch is released. The LED light on the front of the tool
will blink to indicate issues such as improper temperature,
low battery, or maintenance required.
The RP 200-B comes with two (2) fabric loops that can be
used with appropriate attachments such as shoulder
straps or tie off lines.
Fabric Loop
Pressure
Release
Button
Battery
Handle
Tool Housing
Figure 1 – RP 200-B Press Tool And Compact Series Jaw

Specifications

RP 200-B Battery Press Tool:
Motor
Voltage ...................18V DC
Amperage ...............18 Amp
Power .....................324 Watts
Weight ........................5.1 lbs. (2,3 Kg) (Tool Only - No
Battery)
Ram Force .................5,400 lbs. (24kN)
Operating Temperature
Range ...........................15° F to 122° F (-10° C to 50° C)
Duty Cycle...................3 Crimp
Jaw
Attachment
Sideplate
Mounting Pin
Switch
LED
Scissor Style
Light
Jaw Set
Jaw Arm
/min.