Hama 179779 Instrucciones De Uso página 11

4. Getting started – installing the Batteries
Note
• Alkaline batteries are recommended. Use
2 „AAA" (LR 03/Micro) type batteries.
• Remove the battery compartment lid on the back of your URC (A).
• Check the required battery polarity and insert batteries according to the
"+/–" marks inside the compartment (B).
• Close battery compartment lid (C).
Note: Code saver
Any codes you have programmed remain stored for up to 10 minutes while
you replace the battery. Make sure you do not press any buttons before
you have placed new batteries inside the remote control. All the codes will
be erased if a button is pressed while there are no batteries in the remote
control.
Note: Battery saving function
The remote control switches off automatically when a button is pressed
down for more than 15 seconds. This conserves battery power if the remote
control gets stuck in a position where the buttons are continually pressed
down, such as between sofa cushions.
5. Setup
Note
• To obtain a proper infrared (IR) transmission, allways point your Remote
control in the approximate direction of the device you want to control.
• Press the "MODE" key to select the secondary device group: AUX, AMP,
DVB-T, CBL (only 8 in1 Model).
• Press the Shift key to operate the blue function keys. The Shift function
deactivates by pressing the Shift key again, or automatically after approx.
30 sec. without use.
• No entry for approx. 30 seconds will time out the Setup mode. The LED
indicator shows six flashes and turns off.
• Each device type can be programmed under any device key, i.e a TV can
be programmed under DVD, AUX, etc.
• If you want to control a device , it´s not possible while the Universal
Remote Control is in the Setup Mode. Exit the Setup mode and select the
device you want to control using the device selection keys.
9