Troubleshooting - Astralpool FIJI Serie Manual De Instalación Y Mantenimiento

6. TROUBLESHOOTING

1. The pump is not primed
2. The pump releases only a small flow of water
3. The pump makes a noise
1 2 3 4 5 6
Installation and General Maintenance Manual
CAUSES
Air entering the suction pipe
Filter cap badly sealed
Wrong voltage
Pre-filter blocked
Load loss in installation
Pump incorrectly secured
Motor blocked
Increased temperature
The thermal protection trips
For any enquiries on warranties or after-sales service, please contact the vendor
- FIJI
4. The pump will not start
5. The motor is making a noise but will not start
6. The motor is stopped
Ensure that the clamps and hoses are in the correct position
and have been tightened
Clean the filter cap and check the condition of the rubber seal
Check the voltage on the characteristics plate and
that of the mains
Prevent parts from causing load loss wherever possible
Secure the pump correctly
Contact the technical service
Contact the technical service
Contact the technical service
NOTE
SOLUTIONS
Clean the filter
7