Error Messages; Troubleshooting Schedule - Husqvarna PP65 Manual De Instrucciones

Error messages

In case of any faults, a fault message (1) and a fault code (2) appears on the display.
Low voltage detected on voltage bus.
Check the power supply connection.
1
2011-09-09 12:45
2
CODE: F0109
Measures for acknowledging fault messages:
• Press 'OK' on the display or activate the trigger on the connected tool. No further action is required if the fault
message is deleted.
If the system freezes and an acknowledgment can not be made: Pull out the connector from the earthed socket outlet,
reconnect the power source. See instructions in the section "Assembling and adjustments".
If the fault persists, follow the instructions given in the troubleshooting guide or get in touch with an authorized dealer.
Please observe, the illustration shows an example.
The power unit software can be updated. Contact your service agent for further information.

Troubleshooting schedule

Error messages are illustrated in the language you have chosen on the product alternatively in English.
Fault
Error messages
Code
F0101 Over current detected
F0103 Fault detected in hardware
F0104 Error detected on the voltage bus
High voltage detected on voltage bus.
F0105
Check the power supply connection.
Temperature in the IGBT module too
F0106
high
F0107 Emergency stop switch pressed
FXX08* High motor temperature detected
Low voltage detected on voltage bus.
F0109
Check the power supply connection.
The clock has stopped, please correct
F0111
it if neccessary.
F0112 Low input voltage detected
F0113 High input voltage detected
Tool temperature sensor error
FXX14*
detected
F0118 Fault detected in hardware
F0119 Temperature in the PP too high
* XX different numbers depending on the tool that is connected to the power unit.
16 – English
MAINTENANCE
OK OK
Cause
Active tool current too
high
Hardware fault
Tool voltage error
Brakes applied too hard
Power pack overheated
The emergency stop is
pressed in.
Tool motor temperature is
too high
Internal power pack
failure
Clock stopped
Input voltage too low
Input voltage too high
Interruption or short
circuit in the temperature
sensor.
Hardware fault
Power pack overheated
Steps
Contact your service workshop if the
problem remains.
Contact your service workshop if the
problem remains.
Check the power supply
Contact your service workshop if the
problem remains.
Check the fan and filter and allow the
system to cool down.
Reset the emergency stop
Increase the flow of water coolant. Refer
to Technical Data in the instruction
manual for the connected tool.
Check input power or contact service
Contact your service agent for a battery
change.
Check minimum input power in manual
Check maximum input power in manual
Contact your service agent.
Contact your service workshop if the
problem remains.
Check the fan and filter and allow the
system to cool down.