Tabla de contenido
Idiomas disponibles
Idiomas disponibles
o Clean the inside of the cover and the
collar to remove any dirt accumulation.
o Insert new filter into cover,
• Put air filter cover and filter into collar
aligning the tab with the slot,
• Push in on cover and turn clockwise to
tighten.
MUFFLER
Inspect and replace corroded muffler as it
could create a
fire hazard and/or damage.
SPARK
PLUG
Change your spark plug each year to
make your engine start easier and run
better. Set spark plug gap at .030 inch.
Slot
Clip
mum
counter--
clockwise to
remove
Tab
to tighten
Air filter cover
CLEANING
IMPORTANT:
For best performance,
keep mower housing
free of built--up
grass and trash. Clean underside
of
mower housing
after each use.
CAUTION:
Disconnect spark plug wire
from spark plug and place wire where it
cannot come in contact with the spark
plug,
o Turn lawn mower on its side° Make sure
air filter and carburetor are up. Clean the
underside of your lawn mower by
scraping to remove build--up
of grass
and trash.
° Clean engine often to keep trash from
accumulating. A clogged engine runs
hotter and shortens engine life.
= Keep finished surfaces and wheels free
of all gasoline, oil, etc,
° We DO NOT recommend using a
garden hose to clean lawn mower
unless the electrical system, muffler, air
filter and carburetor are covered to keep
water out, Water in engine can result in
shortened engine life.
CAUTION:
Before performing any
service or adjustments:
o
Release control bar,
o
Make sure the blade and all moving
parts have completely stopped.
°
Disconnect spark plug wire from
sparkplug
and place where it cannot
come in contact with plug.
LAWN
MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in
the Operation section of this manual
REAR DEFLECTOR
The rear deflector, attached between the
rear wheels of your lawn mower, is
provided to minimize the possibility that
objects will be thrown out the rear of the
lawn mower into the operator's mowing
position.
If the rear deflector becomes damaged, it
should be replaced.
TO ADJUST HANDLE
Your lawn mower handle can be raised or
lowered for your mowing comfort.
Four
(4) positions are available:
high, medium
high, medium low and low. Handles are
shipped mounted in the medium low
position°
• To change from medium low to medium
high position, the upper and lower
handle sections will have to be turned
over.
o Remove the cable clips.
o Remove the controls and operator
presence control bar from the upper
handle.
° Remove hairpin cotters,
o Disconnect the lower handle from the
handle brackets,
o Turn the handle over and reassemble
the hairpin cotters that have been
removed,
• Reassemble the controls and the
operator presence control bar to the
upper handle,
CAUTION:
The operator presence control
bar must pivot freely to permit blade brake
engagement when control bar is released,
Do not over tighten the fasteners holding
the controls to the upper handle.
• To change from medium low to high
position only the upper handle section
wilt have to be turned over_
I3
Tabla de contenido
